EN25F20-100VC 查看數據表（PDF） - Eon Silicon Solution Inc.

零件编号

产品描述 (功能)

比赛名单

EN25F20-100VC

2 Mbit Serial Flash Memory with 4Kbytes Uniform Sector

Eon Silicon Solution Inc. 

EN25F20

Write Disable (WRDI) (04h)

The Write Disable instruction (Figure 6) resets the Write Enable Latch (WEL) bit in the Status Register to

a 0 or exit from OTP mode to normal mode. The Write Disable instruction is entered by driving Chip

Select (CS#) low, shifting the instruction code “04h” into the DI pin and then driving Chip Select (CS#)

high. Note that the WEL bit is automatically reset after Power-up and upon completion of the Write Status

Register, Page Program, Sector Erase, Block Erase (BE) and Chip Erase instructions.

Read Status Register (RDSR) (05h)

The Read Status Register (RDSR) instruction allows the Status Register to be read. The Status Register

may be read at any time, even while a Program, Erase or Write Status Register cycle is in progress.

When one of these cycles is in progress, it is recommended to check the Write In Progress (WIP) bit

before sending a new instruction to the device. It is also possible to read the Status Register continuously,

as shown in Figure 7.

This Data Sheet may be revised by subsequent versions

9

or modifications due to changes in technical specifications.

©2004 Eon Silicon Solution, Inc., www.essi.com.tw

Rev. B, Issue Date: 2007/05/15

Share Link: