APL5315 查看數據表（PDF） - Anpec Electronics
零件编号
产品描述 (功能)
比赛名单
APL5315 Datasheet PDF : 15 Pages
| |||
APL5315
Typical Application Circuits (Cont.)
2. Adjustable Output Voltage Mode
VIN
CIN
1µF
Enable
Shutdown
Function Description
APL5315
3
VIN
4
VOUT
1 SHDN
5
SET
GND
2
VOUT
R1
COUT
2.2µF
R2
VOUT
= 0.8 ⋅ 1+
R1
R2
Internal Soft-Start
An internal soft-start function controls rising rate of the
output voltage to limit the surge current at start-up. The
typical soft-start interval is about 80µs.
Output Voltage Regulation
The APL5315 can work in either fixed or adjustable mode
by connecting the SET to GND or a resistor-divider which
receives the feedback voltage of the regulator. The output
voltage set by the resistor-divider is determined by:
VOUT
= 0.8 ⋅ 1 + R1
R2
Where R1 is connected from VOUT to SET with Kelvin
sensing and R2 is connected from SET to GND. The
recommended value of R2 is in the range of 100~100kΩ.
An error amplifier working with a temperature compen-
sated 0.8V reference and an output PMOS regulates the
output to the presetting voltage. The error amplifier
designed with high bandwidth and DC gain provides
very fast transient response and less load regulation.
It compares the reference with the feedback voltage and
amplifies the difference to drive the output PMOS which
provides load current from VIN to VOUT.
allowing the device to cool down. The regulator regu-
lates the output again through initiation of a new soft-
start cycle after the junction temperature is cooled down
by 40oC.The thermal shutdown designed with a 40oC hys-
teresis lowers the average junction temperature during
continuous thermal overload conditions, extending life-
time of the device.
For normal operation, device power dissipation should
be externally limited so that junction temperature will not
exceed 125oC.
Shutdown Control
The APL5315 has an active-low shutdown function. Force
SHDN high (>1.6V) enables the VOUT; force SHDN low
(<0.4V) disables the VOUT. SHDN is internally pulled low
by a resistor (3mΩ typical). If it is not used, connect to VIN
for normal operation.
Thermal Shutdown
A thermal shutdown circuit limits the junction tempera-
ture of APL5315. When the junction temperature exceeds
+160οC, a thermal sensor turns off the output PMOS,
Copyright © ANPEC Electronics Corp.
9
Rev. A.4 - Jun., 2008
www.anpec.com.tw
Share Link: 