AS1326 查看數據表（PDF） - austriamicrosystems AG

零件编号

产品描述 (功能)

比赛名单

AS1326

High Current, 0.8A DC-DC Step-Up Converters

austriamicrosystems AG 

AS1326

Datasheet - Application Information

The input filter capacitor reduces peak currents drawn from the input source and also reduces input switching noise.

The input voltage source impedance determines the required value of the input capacitor. When operating directly from

one or two NiMh cells placed close to the AS1326A/AS1326B, use a single 33µF low-ESR input filter capacitor.

Note: With higher impedance batteries, such as alkaline and Li+, a higher value input capacitor may improve effi-

ciency.

The output filter capacitor reduces output ripple voltage and provides the load with transient peak currents when nec-

essary. For the output, a 100µF, low-equivalent series-resistance (ESR) capacitor is recommended for most applica-

tions.

Low-ESR tantalum capacitors offer a good trade-off between price and performance. Do not exceed the ripple current

ratings of tantalum capacitors.

Note: Aluminum electrolytic capacitors should not be used as their high ESR typically results in higher output ripple

voltage.

Additional External Components

Two ceramic bypass capacitors are required for proper device operation (see Figure 20 on page 11):

! Bypass pin REF to GND with a 10nF ceramic capacitor.

! Bypass pin OUT to GND with a 330nF ceramic capacitor.

A 10Ω resistor is required between pin OUT and pin POUT (see Figure 25 on page 14).

Note: External components should be placed as close to its respective pins as possible, within 5mm (0.2”).

Layout Considerations

High switching-frequencies and large peak currents of the AS1326A/AS1326B make PC board layout a critical part of

design. Poor design may cause excessive EMI and ground bounce, both of which can cause instability or regulation

errors by corrupting the voltage and current feedback signals.

! Power components such as the inductor, converter IC, filter capacitors, and output diode should be placed as close

together as possible, and their traces should be kept short, direct, and wide.

! Keep the voltage feedback network very close to the device, within 5mm (0.2”) of the pin.

! Do as many vias as possible on the exposed pad (for thermal performance) to the ground plane

! Keep noisy traces, such as those from the pin LX, away from the voltage feedback network and guarded from

them using grounded copper traces.

www.austriamicrosystems.com

Revision 1.05

15 - 18

Share Link: