CY7C271A 查看數據表（PDF） - Cypress Semiconductor
零件编号
产品描述 (功能)
比赛名单
CY7C271A Datasheet PDF : 10 Pages
| |||
CY7C271A
Switching Waveform
ICC
tPU
CE
CS2
CS1
A0 - A14
O0 - O7
tACE
ADDRA
tAA
DATA A
tPD
ACTIVE
INACTIVE
ACTIVE
ADDRB
tAA
tHZCS
DATA B
tACS
tOH
tHZCE
DATA B
Erasure Characteristics
Wavelengths of light less than 4000 Angstroms begin to erase
the CY7C271A in the windowed package. For this reason, an
opaque label should be placed over the window if the PROM
is exposed to sunlight or fluorescent lighting for extended
periods of time.
The recommended dose of ultraviolet light for erasure is a
wavelength of 2537 Angstroms for a minimum dose (UV
intensity multiplied by exposure time) of 25 Wsec/cm2. For an
ultraviolet lamp with a 12 mW/cm2 power rating, the exposure
time would be approximately 35 minutes. The CY7C271A
needs to be within 1 inch of the lamp during erasure.
Permanent damage may result if the PROM is exposed to
high-intensity UV light for an extended period of time. 7258
Wsec/cm2 is the recommended maximum dosage.
Programming Modes
Programming support is available from Cypress as well as
from a number of third-party software vendors. For detailed
programming information, including a listing of software
packages, please see the PROM Programming Information
located at the end of this section. Programming algorithms can
be obtained from any Cypress representative.
Table 1. Programming Electrical Characteristics
Parameter
Description
VPP
IPP
VIHP
VILP
VCCP
Programming Power Supply
Programming Supply Current
Programming Input Voltage HIGH
Programming Input Voltage LOW
Programming VCC
Min.
12.5
3.0
–0.5
6.0
Max.
13
50
VCC
0.4
6.5
Unit
V
mA
V
V
V
Document #: 38-04013 Rev. *B
Page 4 of 10
Share Link: 