DS2108S 查看數據表（PDF） - Dallas Semiconductor -> Maxim Integrated

零件编号

产品描述 (功能)

比赛名单

DS2108S

Differential SCSI Switchable Terminator

Dallas Semiconductor -> Maxim Integrated 

TYPICAL DIFFERENTIAL SCSI BUS CONFIGURATION Figure 2

DS2108

NOTES:

1. Two DS2108s required per 8–bit SCSI device and three DS2108s per 16–bit SCSI device.

2. Mid–bus termination effectively removed by grounding PD pin.

3. Termination power to be provided as specified in SCSI–3 Parallel Interface (SPI) document.

4. Local TERMPWR bypassing is recommended by the SPI document with values shown. The bypass

capacitors should be located as close as possible to the DS2108s. Only one pair of capacitors is

required per SCSI device (may be shared between DS2108s on same device).

PIN DESCRIPTION Table 1

PIN

SYMBOL DESCRIPTION

1, 11

TPWR Termination Power. Should be connected to the SCSI TERMPWR line.

Bypass with a 2.2 µF cap in parallel with a 0.1 µF cap as shown in Figure

2.

2, 3, 4, 5, 6, R1N…R9N Signal Termination Negative. Connect to –SIGNAL of SCSI bus.

7, 8, 9, 10

12

NC

No Connect. Do not connect any signal to this pin.

13, 23

GND Ground. Signal ground; 0.0V.

14, 15, 16, R1P…R9P Signal Termination Positive. Connect to +SIGNAL of SCSI bus.

17, 18, 19,

20, 21, 22

24

PD

Power Down. When tied low, the DS2108 enters a power-down mode.

Contains an internal 50K pull-up. Strap low to deactivate the DS2108,

leave open circuited to activate the DS2108.

3 of 5

Share Link: