2770EAR 查看數據表（PDF） - Dallas Semiconductor -> Maxim Integrated

零件编号

产品描述 (功能)

比赛名单

2770EAR

Battery Monitor and Charge Controller

Dallas Semiconductor -> Maxim Integrated 

NET ADDRESS FORMAT Figure 14

DS2770

8-Bit CRC

48-Bit Serial Number

8-Bit Family

Code (2Eh)

CRC GENERATION

The DS2770 has an 8-bit CRC stored in the most significant byte of its 64-bit net address. To ensure

error-free transmission of the address, the host system can compute a CRC value from the first 56 bits of

the address and compare it to the CRC from the DS2770. The host system is responsible for verifying the

CRC value and taking action as a result. The DS2770 does not compare CRC values and does not prevent

a command sequence from proceeding as a result of a CRC mismatch. Proper use of the CRC can result

in a communication channel with a very high level of integrity.

The 1-Wire CRC can be generated by the host using a circuit consisting of a Shift Register and XOR

gates as shown in Figure 15, or it can be generated in software. Additional information about the Dallas

1-Wire Cyclic Redundancy Check is available in Application Note 27, Understanding and Using Cyclic

Redundancy Checks with Dallas Semiconductor Touch Memory Products.

In Figure 15, the Shift Register bits are initialized to 0. Then, starting with the least significant bit of the

family code, one bit at a time is shifted in. After the 8th bit of the family code has been entered, the serial

number is entered. After the 48th bit of the serial number has been entered, the Shift Register contains the

CRC value.

1-WIRE CRC GENERATION BLOCK DIAGRAM Figure 15

MSb

XOR

XOR

input

LSb

XOR

HARDWARE CONFIGURATION

Because the 1-Wire bus has only a single line, it is important that each device on the bus be able to drive

it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must connect to the

bus with open-drain or tristate output drivers. The DS2770 uses an open-drain output driver as part of the

bidirectional interface circuitry shown in Figure 16. If a bidirectional pin is not available on the bus

master, separate output and input pins can be tied together.

The 1-Wire bus must have a pull-up resistor at the bus-master end of the bus. For short line lengths, the

value of this resistor should be approximately 5kW. The idle state for the 1-Wire bus is high. If, for any

reason, a bus transaction must be suspended, the bus must be left in the idle state in order to properly

resume the transaction later. If the bus is left low for more than 120ms, slave devices on the bus begin to

interpret the low period as a reset pulse, effectively terminating the transaction.

16 of 27

Share Link: