µPD75P048
3.2 PROM WRITE PROCEDURE
PROMs can be written at high speed using the following procedure: (see the following figure)
(1) Pull unused pins to VSS through resistors. Set the X1 pin low.
(2) Supply 5 volts to the VDD and VPP pins.
(3) Wait for 10 µs.
(4) Select the zero clear program memory address mode.
(5) Supply 6 volts to the VDD and 12.5 volts to the VPP pins.
(6) Select the program inhibit mode.
(7) Write data in the 1 ms write mode.
(8) Select the program inhibit mode.
(9) Select the verify mode. If the data is correct, proceed to step (10). If not, repeat steps (7), (8) and (9).
(10) Perform one additional write (duration of 1 ms × number of writes at (7) to (9)).
(11) Select the program inhibit mode.
(12) Apply four pulses to the X1 pin to increment the program memory address by one.
(13) Repeat steps (7) to (12) until the end address is reached.
(14) Select the zero clear program memory address mode.
(15) Return the VDD and VPP pins back to + 5 volts.
(16) Turn off the power.
The following figure shows steps (2) to (12).
VPP
VPP
VDD
VDD+1
VDD
VDD
X1
X repetition
Write
Verify
Additional write
Address
increment
P40-P43
P50-P53
MD0
(P30)
MD1
(P31)
MD2
(P32)
MD3
(P33)
Input data
Output
data
Input data
15