datasheetbank_Logo
数据手册搜索引擎和 Datasheet免费下载 PDF

IRU1010(2001) 查看數據表(PDF) - International Rectifier

零件编号
产品描述 (功能)
比赛名单
IRU1010
(Rev.:2001)
IR
International Rectifier IR
IRU1010 Datasheet PDF : 6 Pages
1 2 3 4 5 6
IRU1010
PIN DESCRIPTIONS
PIN # PIN SYMBOL PIN DESCRIPTION
1
Adj
A resistor divider from this pin to the Vout pin and ground sets the output voltage.
2
Vout
The output of the regulator. A minimum of 10µF capacitor must be connected from this pin
to ground to insure stability.
3
Vin
The input pin of the regulator. Typically a large storage capacitor is connected from this
pin to ground to insure that the input voltage does not sag below the minimum dropout
voltage during the load transient response. This pin must always be 1.3V higher than Vout
in order for the device to regulate properly.
BLOCK DIAGRAM
Vin 3
2 Vout
+
CURRENT
LIMIT
1.25V +
THERMAL
SHUTDOWN
1010blk1-1.0
Figure 2 - Simplified block diagram of the IRU1010
1 Adj
APPLICATION INFORMATION
Introduction
The IRU1010 adjustable Low Dropout (LDO) regulator is
a three-terminal device which can easily be programmed
with the addition of two external resistors to any volt-
ages within the range of 1.25 to 5.5V. This regulator,
unlike the first generation of the three-terminal regula-
tors such as LM117 that required 3V differential between
the input and the regulated output, only needs 1.3V dif-
ferential to maintain output regulation. This is a key re-
quirement for today’s low voltage IC applications that
typically need 3.3V supply and are often generated from
the 5V supply. Other applications such as high speed
memory termination need to switch the load current from
zero to full load in tens of nanoseconds at their pins,
which translates to an approximately 300 to 500ns cur-
rent step at the regulator. In addition, the output voltage
tolerances are sometimes tight and they include the tran-
sient response as part of the specification.
The IRU1010 is specifically designed to meet the fast
current transient needs as well as providing an accurate
initial voltage, reducing the overall system cost with the
need for fewer output capacitors.
Rev. 1.4
06/29/01
3

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]