LC863528A 查看數據表（PDF） - SANYO -> Panasonic

零件编号

产品描述 (功能)

比赛名单

LC863528A

8-Bit Single-Chip Microcontroller

SANYO -> Panasonic 

LC863532A/28A/24A/20A/16A

(13) Interrupts

- 12 sources 8 vectored interrupts

1. External Interrupt INT0

2. External Interrupt INT1

3. External Interrupt INT2, Timer/counter T0L (Lower 8 bits)

4. External Interrupt INT3, base timer

5. Timer/counter T0H (Upper 8 bits)

6. Timer T1H, Timer T1L

7. Vertical synchronous signal interrupt ( VS ), horizontal line ( HS )

8. IIC

- Interrupt priority control

Three interrupt priorities are supported (low, high and highest) and multi-level nesting is possible. Low or high

priority can be assigned to the interrupts from 3 to 8 listed above. For the external interrupt INT0 and INT1, low or

highest priority can be set.

(14) Sub-routine stack level

- A maximum of 128 levels (stack is built in the internal RAM)

(15) Multiplication/division instruction

- 16 bits × 8 bits (7 instruction cycle times)

- 16 bits / 8 bits (7 instruction cycle times)

(16) 3 oscillation circuits

- Built-in RC oscillation circuit used for the system clock

- Built-in VCO circuit used for the system clock and OSD

- X’tal oscillation circuit used for base timer, system clock and PLL reference

(17) Standby function

- HALT mode

The HALT mode is used to reduce the power dissipation. In this operation mode, the program execution is

stopped. This mode can be released by the interrupt request or the system reset.

- HOLD mode

The HOLD mode is used to stop the oscillations; RC (internal), VCO, and X’tal oscillations. This mode can be

released by the following conditions.

• Pull the reset terminal ( RES ) to low level.

• Feed the selected level to either P70/INT0 or P71/INT1.

(18) Package

- MFP36S

- DIP36S

(19) Development tools

- Flash EEPROM:

- Evaluation chip:

- Emulator:

LC86F3548A

LC863096

EVA86000 (main) + ECB863400 (evaluation chip board)

+ POD36-CABLE (cable)

+ POD36-DIP (for DIP36S)

or POD36-MFP (for MFP36S)

No.6844-4/19

Share Link: