M52390 查看數據表（PDF） - Mitsumi

零件编号

产品描述 (功能)

比赛名单

M52390

NTSC/PAL ENCODER

Mitsumi 

(7) Driving of input pins

Drive pins 9 , 16 , 17 and 18 at low impedance because they

are clamped by IC input.

(8) I/O relation between sync signal and burst signal

during the period V

2 C.Sync IN

MITSUBISHI ICs (AV COMMON)

M52390FP

NTSC/PAL ENCODER

10

VIDEO

(Ts:Hi)

OUT

Sync signal

Burst signal

I/O relation between sync signal and burst signal

(9) Setting of V DL and Ys DL in superimpose mode

1) V DL is used to adjust the timing of RGB encode signal and

VIDEO IN signal.

2) Ys DL is used to adjust the timing of RGB encode signal and Ys

IN signal.

3) In case that signals are input to C.SYNC IN, RGB IN, VIDEO IN

or Ys IN at the same timing, set V DL and Ys DL based on the

delay volume as below.

V DL = Y DL (Refer to (4)) + 10 (nsec)

Ys DL = Y DL - 10 (nsec)

Share Link: