MAX848 查看數據表（PDF） - Maxim Integrated

零件编号

产品描述 (功能)

比赛名单

MAX848

1-Cell to 3-Cell, High-Power, Low-Noise, Step-Up DC-DC Converters

Maxim Integrated 

1-Cell to 3-Cell, High-Power,

Low-Noise, Step-Up DC-DC Converters

FEEDBACK

REF

PWM-MODE

CURRENT-

LIMIT LEVEL

OSC

RQ

S

POUT

P

LX

N

PGND

OUT

MAX848

MAX849

POKIN

FB

GND POK

OUTPUT

R1

R2

R3

Figure 4. Controller Block Diagram in PWM Mode

where VREF = 1.25V, VOUT is the desired output volt-

age, and VTRIP is the desired trip level for the power-

good comparator.

Power-OK

The MAX848/MAX849 feature a power-good compara-

tor. This comparator’s open-drain output, POK, is

pulled low when the output voltage falls below the nom-

inal internal threshold level of 3V with POKIN = 0V. To

set the power-good trip level externally, refer to the

Setting the Output Voltage Externally section.

Analog-to-Digital Converter (ADC)

The MAX848/MAX849 have an internal, two-channel, seri-

al ADC. The ADC converts an analog input voltage into a

digital stream available at the DATA pin. The converter

skips clock pulses in proportion to the input voltage.

Output format is a return-to-zero bit stream with a bit

duration of 1/fCLK. At zero-scale input voltage, all pulses

are skipped and DATA remains low; with a positive full-

scale input voltage, no pulses are skipped; and at mid-

scale, every other pulse is skipped. The ADC’s clock is

one-half of the externally applied clock signal or one-half

of the internal 300kHz clock available at LX. In PFM

mode, the converter is not active and DATA is driven low.

Channel 1, AIN1, has an input voltage range of 0.625V

to 1.875V and is selected when AINSEL is low. Channel

2, AIN2, accepts inputs in the 0V to 2.5V range and is

selected when AINSEL is pulled high (Figure 6).

The ADC is a switched-capacitor type; therefore, an

anti-aliasing filter might be required at the inputs. Insert

a 1kΩ series resistor and a 0.01µF filter capacitor in

noisy environments.

Figure 5. Adjustable Output Voltage and Power-Good Trip Level

AIN1

AINSEL

AIN2

2 x REF

C

C

C/2

REF

DQ

C/2

OSC

÷2

DATA

Figure 6. A/D Converter Block Diagram

Timer Function Implementation

Implement the necessary counter functions either with

discrete hardware or with microcontroller (µC) imple-

mentations. The output resolution depends on how

many of the ADC clock pulses are counted, as shown

in Figure 7.

Hardware Implementation

A complete hardware solution can be implemented

using either two counters or an ASIC. Resolution

depends on how many pulses are counted. The main

advantage of the discrete hardware implementation is

that accuracy is not affected by interrupt latency asso-

ciated with the µC solution.

______________________________________________________________________________________ 11

Share Link: