MIC94084 查看數據表（PDF） - Micrel

零件编号

产品描述 (功能)

比赛名单

MIC94084

67mΩ RDSON 2A High Side Load Switch in 0.85mm x 0.85mm Thin MLF® Package

Micrel 

MB91F127/F128

• Function entry/exit instructions, multi load/store instruction for register data : High-level language compatible

instructions

• Register interlock functions : Simple description of assembler language

• Branch instructions with delay slot : Reduced overhead on branching process

• Built-in multiplier/ Supporting at instruction level

Signed 32-bit multiplying : 5 cycles

Signed 16-bit multiplying : 3 cycles

• Interrupt (saving PC and PS) : 6 cycles, 16 priority levels

Bus interface

• Maximum of 25 MHz internal operation rate

• 25-bit address bus (32 MB space)

• 16-bit address output, 8/16-bit data input/output

• Basic bus cycle : 2-clock cycle

• Chip selection outputs specifiable in a minimum of 64 Kbytes steps : 6 outputs

• Automatic wait cycle : Specifiable flexibly from 0 cycle to 7 cycles for each area

• Supporting time-division input/output interface for address/data (for area 1 only)

• Unassigned data/address terminals are available as input/output ports

• Supporting little endian mode (selecting one area from area 1 to area 5)

DMAC (DMA controller)

• 8 channels

• Transfer factor : Interrupt request of built-in resources

• Transfer sequence : Step transfer/Block transfer/Burst transfer/Consecutive transfer

• Transfer data length : Selectable among 8 bits, 16 bits, and 32 bits

• Pausing is allowed by interrupt request

UART

• 3 channels

• Full-duplex double buffer

• Data length : 7 to 9 bits (no parity), 6 to 8 bits (with parity)

• Asynchronous (start-stop synchronization) or CLK synchronous communication is selectable

• Multi processor mode

• Built-in 16-bit timer (U-Timer) used as a baud-rate generator : Generates an arbitrary baud rate

• External clock is available as a transfer clock

• Error detection : parity, frame, and overrun

A/D converter (sequential transducer)

• 8/10-bit resolution, 8 channels

• Sequential comparison and transducer : At 25 MHz, 5.2 µs

• Built-in sample and hold circuit

• Conversion mode : Selectable among single conversion, scan conversion, and repeat conversion

• Activation : Selectable among software, external trigger, and built-in timer

Reload timer

• 16-bit timer : 3 channels

• Internal clock : 2-clock cycle resolution, selectable among 2/8/32 dividing and external clock

(Continued)

2

Share Link: