ST63E73 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

比赛名单

ST63E73

8-BIT ROM/OTP/EPROM MCUs FOR DIGITALLY CONTROLLED MULTISYNC/MULTISTANDARD MONITORS

STMicroelectronics 

ST6373

MEMORY SPACES (Cont’d)

Data ROM Addressing. All the read-only data are

physically implemented in the ROM in which the

Program Space is also implemented. The ROM

therefore contains the program to be executed and

also the constants and the look-up tables needed

for the program. The locations of Data Space in

which the different constants and look-up tables

are addressed by the ST6 Core can be considered

as being a 64-byte window through which it is pos-

sible to access to the read-only data stored in the

ROM. This window is located from the 40h ad-

dress to the 7Fh address in the Data space and al-

lows the direct reading of the bytes from the 000h

address to the 03Fh address in the ROM. All the

bytes of the ROM can be used to store either in-

structions or read-only data. Indeed, the window

can be moved by step of 64 bytes along the ROM

in writing the appropriate code in the Write-only

Data ROM Window register (DRWR, location

C9h). The effective address of the byte to be read

as a data in the ROM is obtained by the concate-

nation of the 6 less significant bits of the address in

the Data Space (as less significant bits) and the

content of the DRWR (as most significant bits). So

when addressing location 40h of data space, and

0 is loaded in the DRWR, the physical addressed

location in ROM is 00h.

Data ROM Window Register (DWR)

Address: C9h - Write only

Reset Value: XXh

7

0

DWR7 DWR6 DWR5 DWR4 DWR3 DWR2 DWR1 DWR0

DWR7-DWR0. These are the Data Rom Window

bits that correspond to the upper bits of data ROM

program space. This register is undefined after re-

set.

Note:

Care is required when handling the DRWR as it is

write only. For this reason, it is not allowed to

change the DRWR contents while executing inter-

rupts drivers, as the driver cannot save and than

restore its previous content. If it is impossible to

avoid the writing of this register in interrupts driv-

ers, an image of this register must be saved in a

RAM location, and each time the program writes

the DRWR it writes also the image register. The

image register must be written first, so if an inter-

rupt occurs between the two instructions the

DRWR register is not affected.

Figure 6. Data ROM Window Memory Addressing

DATA ROM

13 12 11 10 9 8 7 6 5 4 3 2 1 0 PROGRAM SPACE ADDRESS

WINDOW REGISTER 7 6 5 4 3 2 1 0

READ

CONTENTS

(DWR)

5 4 3 2 1 0 DATA SPACE ADDRESS

01

40h-7Fh

IN INSTRUCTION

Example:

DWR=28h 0 0 1 0 1 0 0 0

DATA SPACE ADDRESS

0 10 1100 1

59h

ROM

ADDRESS:A19h 0 0 1 0 1 0 0 0 0 1 1 0 0 1

VR01573B

11/64

Share Link: