SC1185A 查看數據表（PDF） - Semtech Corporation

零件编号

产品描述 (功能)

生产厂家

SC1185A

PROGRAMMABLE SYNCHRONOUS DC/DC CONVERTER, DUAL LOW DROPOUT REGULATOR CONTROLLER

Semtech Corporation 

PROGRAMMABLE SYNCHRONOUS DC/DC

CONVERTER, DUAL LOW DROPOUT

REGULATOR CONTROLLER

SC1185

SC1185A

PRELIMINARY - January 6, 1999

4) The Output Capacitor(s) (Cout) should be located

as close to the load as possible, fast transient load

currents are supplied by Cout only, and connections

between Cout and the load must be short, wide cop-

per areas to minimize inductance and resistance.

5) The SC1185 is best placed over a quiet ground

plane area, avoid pulse currents in the Cin, Q1, Q2

loop flowing in this area. PGNDH and PGNDL should

be returned to the ground plane close to the package.

The AGND pin should be connected to the ground

side of (one of) the output capacitor(s). If this is not

possible, the AGND pin may be connected to the

ground path between the Output Capacitor(s) and the

Cin, Q1, Q2 loop. Under no circumstances should

AGND be returned to a ground inside the Cin, Q1, Q2

loop.

6) Vcc for the SC1185 should be supplied from the 5V

supply through a 10Ω resistor, the Vcc pin should be

decoupled directly to AGND by a 0.1µF ceramic ca-

pacitor, trace lengths should be as short as possible.

7) The Current Sense resistor and the divider across

it should form as small a loop as possible, the traces

running back to CS+ and CS- on the SC1185 should

run parallel and close to each other. The 0.1µF ca-

pacitor should be mounted as close to the CS+ and

CS- pins as possible.

8) Ideally, the grounds for the two LDO sections

should be returned to the ground side of (one of) the

output capacitor(s).

5V

+

Vout

+

Currents in various parts of the power section

© 1999 SEMTECH CORP.

9

652 MITCHELL ROAD NEWBURY PARK CA 91320

Share Link: