datasheetbank_Logo
数据手册搜索引擎和 Datasheet免费下载 PDF

TC77 查看數據表(PDF) - Microchip Technology

零件编号
产品描述 (功能)
比赛名单
TC77
Microchip
Microchip Technology Microchip
TC77 Datasheet PDF : 22 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
TC77
CS
tCS-SCK
CLK
1
8
13
SI/O
HI-Z T T T T T T T T T T T T T
12 11 10 9 8 7 6 5 4 3 2 1 0
HI-Z
FIGURE 3-2:
Temperature Read Timing Diagram - (Reading only the first 13 Bits of the
Temperature Register).
CS
tCS-SCK
CLK
1
81
81
81
8
SI/O HI-Z T T T T T T T T T T T T T BIT HI-Z C C C C C C C C C C C C C C C C HI-Z
12 11 10 9 8 7 6 5 4 3 2 1 0 2
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
TEMPERATURE REGISTER
Notes:
1. Bit 2 = 0 during power-up for the first
temperature conversion.
2. Bit 2 =1 after the completion of the first tem-
perature conversion following power-up or a
reset event.
3. Bits 1 and 0 are “DON”T CARES”.
CONFIGURATION REGISTER
Notes:
1. XX00 = Continuous Conversion Mode
2. XXFF = Shutdown Mode
FIGURE 3-3:
Diagram.
Temperature Read Followed By A Write To The Configuration Register Timing.
It is recommended that the user write all ‘0’s or all ‘1’s
to the Configuration register. While the following codes
can be transmitted to the TC77, any other code may
put the TC77 into a test mode reserved by Microchip for
calibration and production verification tests.
The following communication steps can be used to
obtain the Manufacturer's ID and put the device into the
Continuous Conversion mode. The Manufacturer’s ID
register is only accessible for a read operation, if the
TC77 is in Shutdown mode.
• 00 hex
• 01 hex
• 03 hex
• 07 hex
• 0F hex
• 1F hex
• 3F hex
• 7F hex
• FF hex
1. CS goes low to initiate the communication cycle.
2. Read 16 bits of temperature data from the
Temperature register.
3. Write 16 bits of data (i.e. XXFF hex) to the Con-
figuration register to enter Shutdown mode.
4. Read the 16 bits from the Manufacturer's ID reg-
ister (C15:C8 = 54 hex) to verify that the sensor
is a Microchip device.
5. Write 8 to 16 bits of data (00 or 0000 hex) to
enter Continuous Conversion Mode.
6. Return CS high to terminate the communication
cycle.
The time between a complete temperature conversion
and data transmission is approximately 300 msec.
DS20092B-page 10
2002-2012 Microchip Technology Inc.

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]