ADG714(Rev0) 查看數據表（PDF） - Analog Devices

零件编号

产品描述 (功能)

比赛名单

ADG714
(Rev.:Rev0)

CMOS, Low Voltage Serially-Controlled, Octal SPST Switches

Analog Devices 

four devices on the SPI bus. Figure 23 illustrates the ADG739 and

multiple ADG714s in such a typical configuration. All devices

receive the same serial clock and serial data, but only one device

will receive the SYNC signal at any one time. The ADG739 is a

serially controlled device also. One bit programmable pin of the

microcontroller is used to enable the ADG739 via SYNC2,

while another bit programmable pin is used as the chip select for

the other serial devices, SYNC1. Driving SYNC2 low enables

changes to be made to the addressed serial devices. By bringing

SYNC1 low, the selected serial device hanging from the SPI bus

will be enabled and data will be clocked into its shift register on

the falling edges of SCLK. The convenient design of the matrix

switch allows for different combinations of the four serial

devices to be addressed at any one time. If more devices need

to be addressed via one chip select line, the ADG738 is an 8-

channel device and would allow further expansion of the chip

select scheme. There may be some digital feedthrough from the

digital input lines because SCLK and DIN are permanently

connected to each device. Using a burst clock will minimize the

effects of digital feedthrough on the analog channels.

ADG714/ADG715

ADG714

SYNC

DIN

SCLK

VDD

SYNC1

FROM

␮CONTROLLER

OR DSP

SYNC2

1/2 of ADG739

S1A

S2A

DA

S3A

S4A

SCLK DIN SYNC

SCLK

DIN

ADG714

SYNC

DIN

SCLK

OTHER

SPI

SYNC DEVICE

DIN

SCLK

OTHER

SPI

SYNC DEVICE

DIN

SCLK

Figure 23. Addressing Multiple ADG714s Using an

ADG739

REV. 0

–15–

Share Link: