WM9704M 查看數據表（PDF） - Wolfson Microelectronics plc

零件编号

产品描述 (功能)

生产厂家

WM9704M

AMC’97 Audio and Modem Codec

Wolfson Microelectronics plc 

Production Data

WM9704M

SLOT 12 : GPIO CONTROL

Data in this slot is applied to the GPIO pins, if they have been enabled via the control registers.

Note that only bits 11, 12 and 13 are supported, all others are ignored.

AC-LINK AUDIO INPUT FRAME (SDATA_IN)

SYNC

BIT_CLK

TAG PHASE

12.288MHz

81.4nS

DATA PHASE

20.8µS (48kHz)

SDATA_IN

CODEC

READY

SLOT(1)

SLOT(2)

SLOT(12) ’0’ ’0’ ’0’ 19

0

END OF PREVIOUS

AUDIO FRAME

TIME SLOT ’VALID’ BITS

(’1’ = TIME SLOT CONTAINS

VALID PCM DATA)

SLOT (1)

19

0

SLOT (2)

19

0

SLOT (3)

19

0

SLOT (12)

Figure 11 AC-link Audio Input Frame

The audio input frame data streams correspond to the multiplexed bundles of all digital input data

targeting the AC’97 controller. As is the case for audio output frame, each AC-link audio input frame

consists of 12, 20-bit time slots.

Slot 0 is a special reserved time slot containing 16-bits, which are used for AC-link protocol

infrastructure.

Within slot 0 the first bit is a global bit (SDATA_IN slot 0, bit 15) which flags whether the WM9704M

is in the “Codec Ready” state or not. If the “Codec Ready” bit is a 0, this indicates that the WM9704M

is not ready for normal operation. This condition is normal following the desertion of power on reset

for example, while the WM9704M’s voltage references settle. When the AC-link “Codec Ready”

indicator bit is a 1, it indicates that the AC-link and the WM9704M control and status registers are in

a fully operational state. The AC’97 controller must further probe the Powerdown Control/Status

Register to determine exactly which subsections, if any, are ready.

Prior to any attempts at putting the WM9704M into operation the AC’97 controller should poll the first

bit in the audio input frame (SDATA_IN slot 0, bit 15) for an indication that the WM9704M has gone

“Codec Ready”.

Once the WM9704M is sampled “Codec Ready” then the next 12 bit positions sampled by the AC’97

controller indicate which of the corresponding 12 time slots are assigned to input data streams, and

that they contain valid data. Figure 11 illustrates the time slot based AC-link protocol.

There are several subsections within the WM9704M that can independently go busy/ready. It is the

responsibility of the WM9704M controller to probe more deeply into the WM9704M register file to

determine which the WM9704M subsections are actually ready.

WOLFSON MICROELECTRONICS LTD

PD Rev 3.2 January 2001

21

Share Link: