Parameter and Conditions
at Tj = 25 °C, Vbb = 12 V unless otherwise specified
Symbol
BTS 426 L1
Values
Unit
min typ max
Operating current (Pin 1)8), VIN=5 V,
Tj =-40...+150°C
Protection Functions
Initial peak short circuit current limit (pin 3 to 5)
Tj =-40°C:
Tj =25°C:
Tj =+150°C:
Repetitive short circuit shutdown current limit
Tj = Tjt (see timing diagrams, page 10)
Output clamp (inductive load switch off)
at VOUT = Vbb - VON(CL)
IL= 40 mA:
Thermal overload trip temperature
Thermal hysteresis
Reverse battery (pin 3 to 1) 9)
Reverse battery voltage drop (Vout > Vbb)
IL = -4 A
Tj=150 °C:
IGND
IL(SCp)
IL(SCr)
VON(CL)
Tjt
∆Tjt
-Vbb
-VON(rev)
-- 1.8 3.5 mA
21 32
15 25
11 17
-- 16
41 47
150
--
-- 10
--
--
-- 610
43 A
35
24
-- A
53 V
-- °C
-- K
32 V
-- mV
Diagnostic Characteristics
Open load detection current
(on-condition)
Open load detection voltage10)
Tj=-40 °C:
Tj=25 ..150°C:
(off-condition)
Tj=-40..150°C:
Internal output pull down
(pin 5 to 1), VOUT=5 V, Tj=-40..150°C
IL (OL)
VOUT(OL)
RO
20
-- 850 mA
10
-- 750
2
3
4V
4 10 30 kΩ
8) Add IST, if IST > 0, add IIN, if VIN>5.5 V
9) Requires 150 Ω resistor in GND connection. The reverse load current through the intrinsic drain-source
diode has to be limited by the connected load. Note that the power dissipation is higher compared to normal
operating conditions due to the voltage drop across the intrinsic drain-source diode. The temperature
protection is not active during reverse current operation! Input and Status currents have to be limited (see
max. ratings page 2 and circuit page 7).
10) External pull up resistor required for open load detection in off state.
Semiconductor Group
4