PN511 查看數據表（PDF） - NXP Semiconductors.
零件编号
产品描述 (功能)
比赛名单
PN511 Datasheet PDF : 22 Pages
| |||
NXP Semiconductors
PN511
Transmission Module
7.2 Pin description
Table 3. Pin description HVQFN32
Symbol
Pin
Type Description
A1
1
I
Address Line
PVDD
2
PWR Pad power supply
DVDD
3
PWR Digital Power Supply
DVSS
4
PWR Digital Ground
PVSS
5
PWR Pad power supply ground
NRSTPD 6
I
Not Reset and Power Down: When LOW, internal current sinks are switched off, the
oscillator is inhibited, and the input pads are disconnected from the outside world. With
a positive edge on this pin the internal reset phase starts.
SIGIN
7
I
Communication Interface Input: accepts a digital, serial data stream
SIGOUT 8
O
Communication Interface Output: delivers a serial data stream
LOADMOD 9
O
Load Modulation Output: provides digital signal for FeliCa and Mifare Card Operation
mode
TVSS
10
PWR Transmitter Ground: supplies the output stage of TX1 and TX2
TX1
11
O
Transmitter 1: delivers the modulated 13.56 MHz energy carrier
TVDD
12
PWR Transmitter Power Supply: supplies the output stage of TX1 and TX2
TX2
13
O
Transmitter 2: delivers the modulated 13.56 MHz energy carrier
TVSS
14
PWR Transmitter Ground: supplies the output stage of TX1 and TX2
AVDD
15
PWR Analog Power Supply
VMID
16
PWR Internal Reference Voltage: This pin delivers the internal reference voltage.
RX
17
I
Receiver Input
AVSS
18
PWR Analog Ground
AUX1
19
O
Auxiliary Outputs: These pins are used for testing.
AUX2
20
O
OSCIN
21
OSCOUT 22
I
Crystal Oscillator Input: input to the inverting amplifier of the oscillator. This pin is
also the input for an externally generated clock (fosc = 27.12 MHz).
O
Crystal Oscillator Output: Output of the inverting amplifier of the oscillator.
IRQ
23
O
Interrupt Request: output to signal an interrupt event
ALE
24
I
Address Latch Enable: signal to latch AD0 to AD5 into the internal address latch
when HIGH.
D1 to D7 25 to 31 I/O
8-bit Bi-directional Data Bus.
Remark: An 8-bit parallel interface is not available.
Remark: If the host controller selects I2C as digital host controller interface, these pins
can be used to define the I2C address.
Remark: For serial interfaces this pins can be used for test signals or I/Os.
A0
32
I
Address Line
082733
Product short data sheet
Rev. 3.3 — 13 June 2007
© NXP B.V. 2007. All rights reserved.
8 of 22
Share Link: 