STK403-090 查看數據表（PDF） - SANYO -> Panasonic
零件编号
产品描述 (功能)
比赛名单
STK403-090 Datasheet PDF : 6 Pages
| |||
*Specifications and information herein are subject to change without notice.
Note *1.1channel Operation.
*2.All tests are measured using a constant-voltage supply unless otherwise specified.
*3.The output noise voltage is peak value of an average-reading meter with a rms value scale(VTVM).
A regulated AC supply(50Hz) should be used to eliminate the effects of AC primary line flicker noise.
*4.Available time for load short-circuit and output noise voltage are measured using the specified
transformer power supply.
*5.Please keep the condition always most below Voltage ‘–Pre Vcc(#1pin)’.
*6.In case of heat sink design, we request customer to design in the condition to have assumed market.
*7.Please specify resistance value by satisfying ‘#13(Stand-By)pin’ Maximum Operating Current.
This Circuit change operation mode to give above VBE(about 0.6v) voltage at ‘#13(Stand-By)pin’.
*8.The case of this Hybrid-IC is using thermoplastic adhesive.
Specified Transformer Power Supply
DBA40C
10000u
+
+
10000u
+Vcc
500ohm
500ohm
-Vcc
(Equivalent to MG-250)
Sanyo Electric Co.,Ltd. Module Systems Division
NO.2
Share Link: 