MX629 查看數據表（PDF） - CML Microsystems Plc
零件编号
产品描述 (功能)
比赛名单
MX629 Datasheet PDF : 16 Pages
| |||
Delta Modulation CODEC
4
2 Signal List
MX629
J/P LH
Name
Signal
Description
1 1 Xtal/Clock
input
Input to the clock oscillator inverter. A 1.024MHz Xtal input or
externally derived clock is injected here. See Clock Mode pins and
Figure 2.
2 N/C
No Connection
2 3 Xtal
output The 1.024 MHz output of the clock oscillator inverter.
3 4 N/C
No Connection
4 5 Encoder Data
Clock
input/ A logic I/O port. External encode clock input or internal data clock
output output. Clock frequency is dependent upon Clock Mode 1, 2 inputs
and Xtal frequency (see Clock Mode pins).
5 6 Encoder Output
output The encoder digital output. This is a three-state output whose
condition is set by the Data Enable and Powersave inputs. See
Table 2.
6 7 Encoder Force Idle
When this pin is at a logical “0” the encoder is forced to an idle
state and the encoder digital output is 0101, a perfect idle pattern.
When this pin is a logical “1” the encoder encodes as normal.
Internal 1M pullup.
7 8 Data Enable
input Data is made available at the encoder output pin by control of this
input. See Encoder Output pin. Internal 1 M pullup.
8 9 N/C
No Connection
9 10 VBIAS
Normally at VDD/2 bias, this pin should be externally decoupled by
capacitor C4. Internally pulled to VSS when “ Powersave ” is a
logical “0”.
10 11 Encoder Input
input
The analog signal input. Internally biased at VDD/2, this input
requires an external coupling capacitor. The source impedance
should be less than 100. Output channel noise levels will
improve with an even lower source impedance. See Figure 2.
11 12 VSS
12 13 N/C
power Negative Supply
No Connection
13 14 Decoder Output
output The recovered analog signal is output at this pin. It is the buffered
output of a lowpass filter and requires external components.
During “Powersave” this output is open circuit.
14 15 N/C
No Connection
15 16 Powersave
A logic “0” at this pin puts most parts of the codec into a quiescent
non-operational state. When at a logical “1”, the codec operates
normally. Internal 1 M pullup.
17 N/C
No Connection
16 18 Decoder Force Idle
A logic “0” at this pin gates a 0101... pattern internally to the
decoder so that the Decoder Output goes to VDD/2. When this pin
is a logical “1” the decoder operates as normal. Internal 1M
pullup.
17 19 Decoder Input
The received digital signal input. Internal 1 M pullup.
18 20 Decoder Data
Clock
input/ A logic I/O port. External decode clock input or internal data clock
output output, dependent upon clock mode 1,2 inputs. See Clock Mode
pins.
19 21 Algorithm
A logic “1” at this pin sets this device for a 3-bit companding
algorithm. A logical “0” sets a 4-bit companding algorithm. Internal
1 M pullup.
1998 MX-COM, Inc.
www.mxcom.com Tel: 800 638 5577 336 744 5050 Fax: 336 744 5054
Doc. # 20480190.001
4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA All Trademarks and service marks are held by their respective companies.
Share Link: 