STM32-E407 查看數據表（PDF） - Unspecified

零件编号

产品描述 (功能)

比赛名单

STM32-E407

STM32-E407 development board USER’S MANUAL

Unspecified 

OLIMEX© 2013

STM32-E407 user's manual

CHAPTER 2 SETTING UP THE STM32-E407 BOARD

2. Introduction to the chapter

This section helps you set up the STM32-E407 development board for the first time.

Please consider first the electrostatic warning to avoid damaging the board, then discover the

hardware and software required to operate the board.

The procedure to power up the board is given, and a description of the default board behavior is

detailed.

2.1 Electrostatic warning

STM32-E407 is shipped in a protective anti-static package. The board must not be exposed to high

electrostatic potentials. A grounding strap or similar protective device should be worn when

handling the board. Avoid touching the component pins or any other metallic element.

2.2 Requirements

In order to set up the STM32-E407 optimally, the following items are required:

- JTAG or SWD interface programmer/debugger – can power the board and gives the ability to

program/debug the board – to choose the correct programmer be sure that you are aware what

software tools you are going to use when programming STM32-E407, and that the programmer

supports STM32F407 processor.

Additional components can be acquired in order to increase the functionality of the board:

- External power supply

- USB type “A” to USB type “mini” cable is required for bootlader

- SD-card or extension UEXT modules are recommended but not required

- 3.7V Battery

- MOD-XXXX boards for additional features on the UEXT (RTC, TC, GSM, MP3, RS-485 among

others) – note that you will have to implement the software setup between the boards

- Arduino/Maple/Pinguino shields – every shield is hardware compatible with H407 but will not

work out-of-the-box, software implementation should be considered

Some of the suggested items can be purchased by Olimex, for instance:

ARM-USB-TINY-H – high-speed OpenOCD ARM JTAG debugger

ARM-USB-OCD-H – high-speed OpenOCD ARM JTAG debugger with buffer protection

USB-MINI-CABLE USB mini to USB-A cable - USB mini to USB-A cable

BATTERY-LIPO1400MAH – lithium-polymer battery 1400mAh

USB-SERIAL-CABLE-F – easy way to connect the board to a computer terminal program using

the BOOT pins

SY0612E - power supply adapter 12V/0.5A for iMX233-STM32-E407

Page 7 of 30

Share Link: