Bluetooth Audio Module
6.0 Layout Guidelines
BTM98-8AAm
6.0.1 Audio Layout
Route audio lines as differential pairs. The positive and negative signals
should run parallel and close to each other until they are converted to single-ended
signals. Use dedicated audio ground plane for entire audio section.
6.0.2 Antenna Design
Do not place GND plane or any metal directly under the antenna of
BTM-68D. To avoid any excess parasitic capacitance in the antenna feed line caused
by the RF test pin on the bottom side of the module, the area underneath the RF test
pin should also be left free from copper. Any metal in close proximity of the antenna
will have an effect on the antenna performance. Thus any metal should be placed as
far from the antenna as possible. The module should be placed to an edge of the PCB.
Shenzhen TTK Technology CO.,LTD
TEL:0755-89484041 FAX:0755-89484040
14.15