173D335X9006UWE3 查看數據表（PDF） - Vishay Semiconductors

零件编号

产品描述 (功能)

比赛名单

173D335X9006UWE3

Solid-Electrolyte TANTALEX™ Capacitors, Axial-Leaded, Molded Case

Vishay Semiconductors 

www.vishay.com

STANDARD REEL PACKAGING INFORMATION

1. Component Leads

a. Component leads shall not be bent beyond 0.047"

[1.19 mm] maximum from their nominal position when

measured from the leading edge of the component lead

at the inside tape edge and at the lead egress from the

component.

b. The “C” dimension shall be governed by the overall

length of the reel packaged component. The distance

between flanges shall be 0.125" to 0.250" [3.18 mm to

6.35 mm] greater than the overall component length.

2. Orientation

All polarized components must be oriented to one direction.

The cathode lead tape shall be a color and the anode lead

tape shall be white.

3. Reeling

a. Components on any reel shall not represent more than

two date codes when date code identification is required.

b. Component leads shall be positioned between pairs of

0.250" [6.35 mm] tape.

c. The disposable reels have hubs and corrugated

fibreboard flanges and core.

d. A minimum of 12" [304.8 mm] leader of tape shall be

provided before the first and after the last component on

the reel.

e. 50 lb to 60 lb. Kraft paper must be wound between layers

of components as far as necessary for component

protection. Width of paper to be 0.062" to 0.250"

[1.57 mm to 6.35 mm] less than the “C” dimension

of the reel.

PRODUCT INFORMATION

Mounting of Through Hole Components

SELECTOR GUIDES

Quick Reference Guide

Selector Guide

Parameter Comparison Guide

FAQ

Frequently Asked Questions

173D

Vishay Sprague

f. Row components must be centered between tapes

± 0.047" [1.19 mm]. In addition, individual components

may deviate from center of component row ± 0.031"

[0.79 mm].

g. Staples shall not be used for splicing. Not more than

4 layers of tape shall be used in any splice area and no

tape shall be offset from another by more than 0.031"

[0.79 mm] non-cumulative. Tape splices shall overlap

at least 6.0" [152.4 mm] for butt joints and at least

3" [76.2 mm] for lap joints and shall not be weaker than

unspliced tape. Universal splicing clips may also be used.

h. Quantity per reel shall be controlled so that tape

components and cover shall not extend beyond the

smallest dimension of the flange (either across flats or

diameter). Once the quantity per reel for each part

number has been established, future orders for that part

number shall be packaged in that quantity. When order

release quantity is less than the established quantity, a

standard commercial pack is to be used.

i. A maximum of 0.25 % of the components per reel

quantity may be missing without consecutive missing

components.

j. Adequate protection must be provided to prevent

physical damage to both reel and components during

shipment and storage







www.vishay.com/doc?40108

www.vishay.com/doc?40037

www.vishay.com/doc?49054

www.vishay.com/doc?40033

www.vishay.com/doc?40110

Revision: 28-Jun-16

9

Document Number: 40019

For technical questions, contact: tantalum@vishay.com

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

Share Link: