ADP1752-1.5-EVALZ 查看數據表（PDF） - Analog Devices
零件编号
产品描述 (功能)
比赛名单
ADP1752-1.5-EVALZ Datasheet PDF : 20 Pages
| |||
ADP1752/ADP1753
PIN CONFIGURATIONS AND FUNCTION DESCRIPTIONS
Data Sheet
VIN 1
VIN 2
VIN 3
EN 4
PIN 1
INDICATOR
ADP1752
TOP VIEW
(Not to Scale)
12 VOUT
11 VOUT
10 VOUT
9 SENSE
VIN 1
VIN 2
VIN 3
EN 4
PIN 1
INDICATOR
ADP1753
TOP VIEW
(Not to Scale)
12 VOUT
11 VOUT
10 VOUT
9 ADJ
NOTES
1. NC = NO CONNECT.
2. THE EXPOSED PAD ON THE BOTTOM OF THE LFCSP ENHANCES
THERMAL PERFORMANCE AND IS ELECTRICALLY CONNECTED TO GND
INSIDE THE PACKAGE. IT IS RECOMMENDED THAT THE EXPOSED PAD
BE CONNECTED TO THE GROUND PLANE ON THE BOARD.
Figure 3. ADP1752 Pin Configuration
NOTES
1. NC = NO CONNECT.
2. THE EXPOSED PAD ON THE BOTTOM OF THE LFCSP ENHANCES
THERMAL PERFORMANCE AND IS ELECTRICALLY CONNECTED TO GND
INSIDE THE PACKAGE. IT IS RECOMMENDED THAT THE EXPOSED PAD
BE CONNECTED TO THE GROUND PLANE ON THE BOARD.
Figure 4. ADP1753 Pin Configuration
Table 5. Pin Function Descriptions
ADP1752
Pin No.
ADP1753
Pin No.
Mnemonic
1, 2, 3, 15, 16 1, 2, 3, 15, 16 VIN
4
4
EN
5
5
PG
6
6
GND
7
7
SS
8
8
NC
9
N/A
SENSE
N/A
10, 11, 12,
13, 14
17 (EPAD)
9
10, 11, 12,
13, 14
17 (EPAD)
ADJ
VOUT
Exposed
paddle
(EPAD)
Description
Regulator Input Supply. Bypass VIN to GND with a 4.7 µF or greater capacitor. Note that all
five VIN pins must be connected to the source.
Enable Input. Drive EN high to turn on the regulator; drive it low to turn off the regulator. For
automatic startup, connect EN to VIN.
Power Good. This open-drain output requires an external pull-up resistor to VIN. If the part is
in shutdown mode, current-limit mode, thermal shutdown, or if it falls below 90% of the
nominal output voltage, PG immediately transitions low.
Ground.
Soft Start. A capacitor connected to this pin determines the soft start time.
Not Connected. No internal connection.
Sense. This pin measures the actual output voltage at the load and feeds it to the error
amplifier. Connect SENSE as close as possible to the load to minimize the effect of IR drop
between the regulator output and the load.
Adjust. A resistor divider from VOUT to ADJ sets the output voltage.
Regulated Output Voltage. Bypass VOUT to GND with a 4.7 µF or greater capacitor. Note that
all five VOUT pins must be connected to the load.
The exposed pad on the bottom of the LFCSP package enhances thermal performance and
is electrically connected to GND inside the package. It is recommended that the exposed
pad be connected to the ground plane on the board.
Rev. E | Page 6 of 20
Share Link: 