SHIELD-EKG-EMG 查看數據表（PDF） - Unspecified

零件编号

产品描述 (功能)

比赛名单

SHIELD-EKG-EMG

SHIELD-EKG-EMG bio-feedback shield

Unspecified 

OLIMEX© 2014

SHIELD-EKG-EMG user's manual

unrecognized device and choosing Update Driver and then pointing to the folder

where you downloaded and extracted the FTDI VCP driver.

Here it is advisable to go to Device Manager and from advanced settings of our

recognized USB Serial Port (COMx) device to set x to a free port between 1 and 4

(because the monitoring software in this example can read only from COM ports 1 to

4).

9. Start Arduino IDE and open the provided by Olimex project

ShieldEkgEmgDemo.pde

10. Set Tools -> Board -> Arduino Duemilanove w/ ATmega328

Set Tools -> Serial port -> the COM we configured our board at

11. Click Upload (→)

12. Download, install and start the software from this page:

https://www.olimex.com/Products/EEG/OpenEEG/EEG- SMT/resources/ElecGuru40.zip

13. It is advisable to adjust the settings in your ElecGuru program in Preferences->

Trace (waveform)… (depending how many channels/shields you use)

14. Choose the COM port your OLIMEXINO is connected to from Preferences ->

Serial port… (Remember you have to set it to COM 1 to 4)

15. You connect the electrodes to your right arm, left arm and the DLR to your right

leg

16. Start monitoring, adjust the settings until you receive an image like the one shown

on the picture

Page 13 of 20

Share Link: