ST16C554(1994) 查看數據表（PDF） - Exar Corporation

零件编号

产品描述 (功能)

比赛名单

ST16C554
(Rev.:1994)

QUAD UART WITH 16-BYTE FIFO’S

Exar Corporation 

ST16C554/554D/68C554

SYMBOL DESCRIPTION

Symbol

-IOR

-IOW

-IRQ

Pin

Signal

68

64 type

Pin Description

pin a logic 1. Making this pin a logic 0 allows MCR bit-3 to

control the three state interrupt output. In this mode, MCR

bit-3 is set to a logic “1” to enable the three state outputs.

This pin is disabled in the 68 mode. Due to pin limitations on

64 pin packages, this pin is not available. To cover this

limitation, two 64 pin QFP package versions are offered.

The ST16C554DCQ64 operates in the continuos interrupt

enable mode by bonded this pin to VCC internally. The

ST16C554CQ64 operates with MCR bit-3 control by bond-

ing this pin to GND.

52

40

I Read strobe. (active low Strobe) - This function is associ-

ated with the 16 mode only. A logic 0 transition on this pin

will load the contents of an Internal register defined by

address bits A0-A2 onto the ST16C554D data bus (D0-D7)

for access by an external CPU. This pin is disabled in the 68

mode.

18

9

I Write strobe. (active low strobe) - This function is associ-

ated with the 16 mode only. A logic 0 transition on this pin

will transfer the contents of the data bus (D0-D7) from the

external CPU to an internal register that is defined by

address bits A0/A2. When the 16 mode is selected, this pin

functions as -R/W, see definition under R/W.

15

-

O Interrupt Request or Interrupt “A” - This function is associ-

ated with the 68 mode only. In the 68 mode, interrupts from

UART channels A-D are WIRE-OR’ed” internally to function

as a single IRQ interrupt. This pin transitions to a logic 0 (if

enabled by the interrupt enable register) whenever a UART

channel(s) requires service. Individual channel interrupt

status can be determined by addressing each channel

through its associated internal register, using -CS and A3-

A4. In the 68 mode an external pull-up resistor must be

connected between this pin and VCC. The function of this

pin changes to INTA when operating in the 16 mode, see

definition under INTA.

Rev. 3.10

7

Share Link: