CMX661 查看數據表（PDF） - MX-COM Inc

零件编号

产品描述 (功能)

比赛名单

CMX661

Pair Gain Dual SPM Detector

MX-COM Inc  

Pair Gain Dual SPM Detector

Page 9 of 14

CMX661 Advance Information

5.4 Setting Level Sensitivity via External Components

The sensitivities of the two channels are set by the correct selection of the components around the Channel

Input Amplifiers.

Input Gain Calculation: The input amplifiers, with their external circuitry, are available to set the sensitivity of

the CMX661 to conform to the user’s national level specification with regard to ‘Must’ and ‘Must-Not’ decode

signal levels. With reference to the graph in Figure 5, the following steps will assist in the determination of the

required gain/attenuation.

Step 1

Draw two horizontal lines from the Y-axis {Signal Level dB(ref)}

The upper line will represent the required ‘Must’ decode level

The lower line will represent the required ‘Must-Not’ decode level.

Step 2

Mark the intersection of the upper horizontal line and the upper sloping line; drop a vertical line from this point

to the X-axis {Amplifier Gain (dB)}.

The point where the vertical line meets the X-axis will indicate the MINIMUM Input gain required for reliable

decoding of valid signals.

Step 3

Mark the intersection of the lower horizontal line and the lower sloping line; drop a vertical line from this point

to the X-axis.

The point where the vertical line meets the X-axis will indicate the MAXIMUM allowable Input amp gain. Input

signals at or below the ‘Must-Not’ decode level will not be detected as long as the amplifier gain is no higher

than this level.

Step 4

Refer to the gain components shown in Figure 2. The user should calculate and select external components

(R1/R3/C3, R2/R4/C4 and R5/R7/C5, R6/R8/C6) to provide amplifier gains within the limits obtained in Steps 2

and 3.

Component tolerances should not move the gain figure outside these limits. Resistors R3, R4, R7 and R8

should always be greater than or equal to 100kΩ. It is recommended that the designed gain is near the center

of the calculated range.

Note that the device sensitivity is directly proportional to the applied power supply (VDD). The graph in Figure 5

is for the calculation of input gain components for the CMX661 using a VDD of 5.0 (±0.1) volts.

Subtract 4.44dB from the amplifier gain for operation at 3.0V volts.

5.5 Aliasing

Due to the switched-capacitor filters employed in the CMX661, care should be taken to avoid any aliasing

effects by removing all frequencies above 579.390kHz (16kHz mode) or 434.543kHz (12kHz mode). This can

be achieved by adding bypass capacitors across R3, R4, R7 and R8, setting the -3dB breakpoint of each

resistor-capacitor combination such that there is sufficient attenuation at the alias frequency and negligible

effect at the desired SPM frequency.

©2001 MX-COM, INC.

www.mxcom.com Tel: 800 638 5577 336 744 5050 Fax: 336 744 5054

Doc. # 20480228.001

4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA All trademarks and service marks are held by their respective companies.

Share Link: