CY2280PVC-21S 查看數據表（PDF） - SpectraLinear Inc

零件编号

产品描述 (功能)

比赛名单

CY2280PVC-21S

100 MHz Pentium® II Clock Synthesizer/Driver with Spread Spectrum for Mobile or Desktop PCs

SpectraLinear Inc 

Application Information

Clock traces must be terminated with either series or parallel termination, as is normally done.

Application Circuit

CY2280

Summary

• A parallel-resonant crystal should be used as the reference to the clock generator. The operating frequency and CLOAD of

this crystal should be as specified in the data sheet. Optional trimming capacitors may be needed if a crystal with a different

CLOAD is used. Footprints must be laid out for flexibility.

• Surface mount, low-ESR, ceramic capacitors should be used for filtering. Typically, these capacitors have a value of 0.1 PF.

In some cases, smaller value capacitors may be required.

• The value of the series terminating resistor satisfies the following equation, where Rtrace is the loaded characteristic

impedance of the trace, Rout is the output impedance of the clock generator (specified in the data sheet), and Rseries is the

series terminating resistor.

Rseries > Rtrace – Rout

• Footprints must be laid out for optional EMI-reducing capacitors, which should be placed as close to the terminating resistor

as is physically possible. Typical values of these capacitors range from 4.7 pF to 22 pF.

• A Ferrite Bead may be used to isolate the Board VDD from the clock generator VDD island. Ensure that the Ferrite Bead offers

greater than 50: impedance at the clock frequency, under loaded DC conditions. Please refer to the application note “Layout

and Termination Techniques for Cypress Clock Generators” for more details.

• If a Ferrite Bead is used, a 10 PF–22 PF tantalum bypass capacitor should be placed close to the Ferrite Bead. This capacitor

prevents power supply droop during current surges.

Rev 1.0, November 25, 2006

Page 9 of 11

Share Link: