AN2067 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

比赛名单

AN2067

VIPower™: dimmable white LED power supply with the VIPer53-E

STMicroelectronics 

White LED power supply

2

White LED power supply

AN2067

2.1

2.1.1

2.1.2

Schematic

The power topology is an offline flyback, working at a fixed frequency of 66 kHz. The overall

schematic is presented in Figure 2.

Primary section

On the left side of the schematic, the fuse F1, inrush current limiter CTN1, input filter T1,

followed by the rectifier BR1 and its bulk capacitance C3 can be found. R4, C4 and D4 build

the RCD clamper, to discharge the leakage inductance of the transformer.

D2, R2 and C5 are the rectifiers and filters of the primary auxiliary winding, used in forward

mode (refer to Section 3). This generates a voltage supply from 21 V up to 80 V,

proportional to turn ratio between main primary winding and auxiliary primary winding, and

versus input voltage range (110 VAC up to 250 VAC).

A serial voltage regulator is required to supply the VIPer53-E with the correct voltage

(around 12 V). It is built with R14, DZ14, Q1 and C12. The VCE0 of the transistor must be

higher than 80 V. This transistor may also dissipate 0.7 W when the input voltage is 250

VAC.

The COMP pin filter is made of C8, R9 and C9.

Transformer

A current generator may have a large output voltage variation, according to the output load.

If the auxiliary winding is used in flyback mode, a wide voltage variation on auxiliary winding

may happen, as it is proportional to the reflected voltage. So, it is used in forward mode in

order to limit the voltage variation to supply the VIPer53-E.

In order to guarantee the functionality even with low output voltage load, an auxiliary

winding at secondary side has been added. This auxiliary winding is also used in forward

mode.

6/25

DocID10973 Rev 2

Share Link: