1738601-1 查看數據表（PDF） - Tyco Electronics
零件编号
产品描述 (功能)
比赛名单
1738601-1 Datasheet PDF : 6 Pages
| |||
Industrial Circular Ethernet Panel-Mount Connector System
408-8933
NOTE
i
If the conductors do not bottom on the wire
circuits, re-trim them (after removing the load bar
with the cable from the modular plug), and
re-insert the load bar into the modular plug. If the
conductors are too short, re-strip the cable.
e. Using one of the following tools, terminate the
modular plug according to the instructions
included with the tool.
—Modular Plug Hand Tool 2–231652–0 and
Die Set 1–853400–0
—Modular Plug Dual Terminator 1320840–1
—Terminating Module 1–856196–1
—Modular Plug Single Terminator 354711–8 and
Tooling Kit 354714–7
For the common core assembly, proceed as
follows:
a. Open the top shield of the common core
assembly. Make sure that the colors of the cable
conductors match the colors on the color–coded
label. Refer to Figure 5, Detail A.
b. Insert the conductors (maintaining
arrangement) into the conductor guide until the
end of the conductors butt against the end of
the housing. Make sure that the conductors are
NOT twisted in the conductor guide. See Figure
5, Detail B.
c. Close the top shield until there is no gap in
the seam between top shield and the bottom
shield. There will be an audible “click.” Make
sure that the cable braid is located in the strain
relief. See Figure 5, Detail B.
Terminating Common Core Assembly
Detail A
Conductors
Color-Coded
Label
Top Shield Open
s
Detail B
Conductor
Guide
End of
Housing
Bottom Shield
Detail C
4. Align the locking tab (modular plug) or the latch
(common core assembly, located at the end of the
bottom shield) with the wide slot at the front (end
opposite the strain relief) of the plug assembly. See
Figure 6, Detail A.
5. Insert the modular plug (holding the locking tab
down) or common core assembly into the plug
assembly. Gently pull the cable until the modular
plug or common core assembly is fully seated.
There should be approximately 12.7 mm [.50 in.] of
the modular plug or common core assembly
protruding from the front of the plug assembly. See
Figure 6, Detail B.
No Gap in Seam
of Shield
Cable Braid Located
in Strain Relief
Figure 5
NOTE
i
The stated torque must be met in order for the
strain relief to seal the plug assembly at the cable
end.
CAUTION
!
To avoid damage to the connection, the cable
must be pulled GENTLY when seating the
modular plug or common core assembly.
3.2. Receptacle Kit
1. Cut the panel using the dimensions provided in
Figure 7.
6. While holding the modular plug or common core
assembly in position and using a torque tool, rotate
the strain relief as shown in Figure 6, Detail B, until
tightened within the torque given in Figure 6.
NOTE
i
Make sure that the flat edge is located in the
desired rotational orientation.
4 of 6
Tyco Electronics Corporation
Rev D
Share Link: 