MP8831 查看數據表（PDF） - Exar Corporation

零件编号

产品描述 (功能)

比赛名单

MP8831

Single 10-Bit ADC with Digitally Controlled References

Exar Corporation 

MP8831

1

CNTL-A

0

1

CNTL-B

0

t11 Pass-through Input Data

AD[7:0]

(Input)

ADC Output Data

t10

Data A

t12

Data B

t12

Data C

t12

t13

t14

t15

ADC Output Data

DA[7:0]

(Output)

DAC Data Input

Data A

Pass-Through output data

Data B

Data C

Figure 4. Pass-Through Mode (AD=>DA) Timing Diagram

1

CNTL-A

0

1

CNTL-B

0

t16

AD[7:0]

(Output)

ADC Data Output

Pass-Through Output Data

Data A

Data B

DA[7:0]

(Input)

Data A

Pass-through Input Data

t17

t17

Data B

Data C

Data C

t18

ADC Data Output

Figure 5. Pass-Through mode (DA=>AD) Timing Diagram

OPERATION MODES

The two signals CNTL-A & CNTL-B are used to put the

chip into one of the four operation modes.

Convert Mode (CNTL-A=high, CNTL-B=high)

This is the normal operation mode. Data for the offset &

gain DACs is read in from the DA bus, and ADC data is

output on the AD bus.

Pass-Through Mode

AD => DA (CNTL-A=low, CNTL-B=high)

DA => AD (CNTL-A=high, CNTL-B=low)

The pass-through modes are intended to allow the digital

ASIC (or µprocessor, DSP, etc) to read from and write to

the memory bank which holds the gain and offset DAC

data, without requiring a separate data bus between the

ASIC and the memory. In the AD => DA mode, pins

AD[7:0] are programmed as digital inputs, and they

simply pass data (through an internal bus) to pins DA[7:0]

which are programmed as digital outputs. In the DA => AD

mode things are reversed, DA[7:0] are programmed as

Rev. 1.00

9

Share Link: