MX105AP 查看數據表（PDF） - MX-COM Inc

零件编号

产品描述 (功能)

比赛名单

MX105AP

Tone Detector

MX-COM Inc  

Tone Detector

8

MX105A PRELIMINARY INFORMATION

5.5 Select R4 for Operating BW

R4 = 4.8 × BW = 4.8 × 6 ≈ 6.8kΩ

10.35 − BW 10.35 − 6

The exact bandwidth given by any value of R4 will vary slightly. In applications where an exact bandwidth is required, R4

should be a variable resistor to permit adjustment.

5.6 Calculate R2×C2A

R2 × C2A

≈

100

3 × f0 × BW

For a frequency of 2800 Hz, a bandwidth of 6%, and a choice of C2A = 0.01µF ⇒ RV = 200kΩ .

Note: Use nearest preferred values.

5.7 Define Maximum Allowed Response Time

The maximum response time (TON) is the sum of the VCO lock time (TLOCK) and the DETECT integration time (TDETECT).

The MX105A’s TON must not exceed the maximum time allowed for the application, but a value lying near the maximum

gives the best S/N performance.

A. Calculate TLOCK

TLOCK

=

150

f0 × BW

Using the formula above, for a frequency of 2800 Hz and a bandwidth of 6% the approximate Lock time (TLOCK) will be 9

ms. Since the maximum response time is 50 ms, a DETECT time of 41 ms is allowed.

Note: TLOCK may vary from near zero to the value given, causing corresponding variations in actual TON.

B. Calculate Maximum Allowable TDETECT

TDETECT = TONMAX − TLOCK

( ) C. Define Minimum Expected Signal Amplitude VINMIN

This is used in calculating TDETECT components.

5.8 Calculate R3×C3A

R3 × C3A ≈

TDETECT

−3

×



ln1−

VTH

VINMIN





Note:

where: VTH is the detect filter sensitivity.

1. For a signal amplitude of 200 mVRMS, a resistor value R3 of 510 kΩ with a 0.1µF capacitor for C3A and C3B will yield

a TDETECT time of 20ms. This in turn yields a response time of 9ms + 20 ms = 29ms.

2. Use nearest preferred values.

© 1997 MX•COM, INC.

www.mxcom.com Tele: 800 638 5577 910 744 5050 Fax: 910 744 5054

Doc.# 20480133.003

4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA

All trademarks and service marks are held by their respective companies.

Share Link: