5307 查看數據表（PDF） - Pomona Electronics

零件编号

产品描述 (功能)

比赛名单

5307

50 Ω Male BNC Connector and Assembly Instructions

Pomona Electronics 

Model 5307 50 Ω Male BNC Connector and Assembly

Instructions

ASSEMBLY INSTRUCTIONS

Figure #1

1. Cut cable to length and strip per

dimensions:

• outer jacket: 0.320” (8.128 mm)

• inner conductor: 0.140” (3.556 mm)

2. Load the clamp nut, washer and V-Gasket

on to the cable as shown in Figure #1.

Figure #3

4. Install the metal spacer and rear

insulator. Solder the center contact in

place. Make sure the contact is

completely seated against the rear

insulator (see Figure #3).

Figure #2

3. Install the braid clamp onto the cable and

fold the braid back flat as shown in Figure

#2. Make sure that all of the individual

strands of braid are flat against the braid

clamp.

Figure #4

5. Place the front insulator into the

connector housing. The open end of the

insulator should face the front of the

connector housing (see Figure #4).

Sales:

800-490-2361

Fax:

888-403-3360

Technical Support:

800-241-2060

or e-mail us at

technicalsupport@pomonatest.com

Where to Buy: www.pomonaelectronics.com

All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm),

.xxx = ± .005” (,127 mm). All specifications are to the latest revisions.

Specifications are subject to change without notice. Registered trademarks

are the property of their respective companies.

Copyright © 2005 07/2005 2391542 D-ENG-N Rev A Page 2 of 3

Share Link: