AD9480
VOLTAGE REFERENCE
The AD9480 has an internal 1 V reference mode. The ADC
uses the internal 1 V reference as the default when sense is
set to ground. An optional on-board external 1.0 V reference
(ADR510) can be used by setting the sense jumper to AVDD,
by placing a jumper on E20 to E3, and by placing a 0 Ω resistor
on R36. When using an external programmable reference,
(R20, R30) remove the sense jumper.
DATA OUTPUTS
The off-chip drivers provide LVDS compatible output levels
with an LVDS RSET resistor of 3.74 kΩ.
The ADC digital outputs can be terminated on the board by
100 Ω resistors at the connector if receiving logic does not have
the required termination resistance. (The on-chip LVDS output
drivers require a far-end 100 Ω differential termination.)
Rev. 0 | Page 20 of 28