CMX625 查看數據表（PDF） - CML Microsystems Plc

零件编号

产品描述 (功能)

比赛名单

CMX625

ISDN TA POTS Interface

CML Microsystems Plc 

ISDN TA POTS Interface

Figure 6 shows the monitor channel handshake procedure.

CMX625

MX = Monitor Transmit Bit, active low.

MR = Monitor Receive Bit, active high.

MD = Monitor Data

Figure 6 Monitor Channel Handshake Procedure

Figure 7 shows the maximum speed case for monitor handshake timing. The transmitter can be designed

for a higher data throughput than is provided by the general case. The transmitter can deactivate (high)

MX and transmit new data one frame after MR is deactivated. In this way, the transmitter is anticipating

that MR will be reactivated one frame after it is deactivated, minimising the delay between bytes. MR

being held inactive (high) for two or more frames indicates an abort is being signalled by the receiver.

MX

EOM

Data

Byte 1

Byte 2 Byte 3 Byte n

MR

ACK

ACK ACK ACK

Figure 7 Monitor Handshake Timing (maximum speed case)

The abort is a signal from the receiver to the transmitter indicating that data has been missed. The

receiver is able to abort a transmission by holding MR inactive (high) for two or more frames in response

to MX going active. An abort from the receiver will generate an interrupt when the INTERRUPT MASK

Register bit 2 is unmasked (logic ‘1’) and bit 2 of the Status Register will be set to ‘1’. Figure 8 shows a

monitor abort request from the receiver.

 2001 Consumer Microcircuits Limited

12

D/625/2

Share Link: