datasheetbank_Logo
数据手册搜索引擎和 Datasheet免费下载 PDF

CY7C43686-15AC 查看數據表(PDF) - Cypress Semiconductor

零件编号
产品描述 (功能)
比赛名单
CY7C43686-15AC
Cypress
Cypress Semiconductor Cypress
CY7C43686-15AC Datasheet PDF : 39 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
CY7C43646
CY7C43666
CY7C43686
Bus-Matching FIFO1 Reads
Data is written to the FIFO1 RAM in 36-bit long-word incre-
ments. If byte or word size is implemented on Port B, only the
first one or two bytes appear on the selected portion of the
FIFO1 output register, with the rest of the long-word stored in
auxiliary registers. In this case, subsequent FIFO1 reads
output the rest of the long-word to the FIFO1 output register.
When reading data from FIFO1 as byte, the unused B9-17
outputs are indeterminate.
Bus-Matching FIFO2 Writes
Data is written to the FIFO2 RAM in 18-bit word increments.
Data written to FIFO2 with a byte or word bus size stores the
initial bytes or words in auxiliary registers. The CLKC rising
edge that writes the word to FIFO2 also stores the entire
long-word in FIFO2 RAM.
When reading data from FIFO2 in byte format, the unused
C8–17 outputs are LOW.
Retransmit (RT1, RT2)
The retransmit feature is beneficial when transferring packets
of data. It enables the receipt of data to be acknowledged by
the receiver and retransmitted if necessary. Retransmit
function applies to CY standard mode only.
The number of 36-/18-/9-bit words written into the FIFO should
be less than full depth minus 2/4/8 words between the reset of
the FIFO (master or partial) and Retransmit setup. A LOW
pulse on RT1, (RT2) resets the internal read pointer to the first
physical location of the FIFO. CLKA and CLKB may be free
running but RENB and (ENA) must be disabled during and
tRTR after the retransmit pulse. With every valid read cycle
after retransmit, previously accessed data is read and the read
pointer is incremented until it is equal to the write pointer. Flags
are governed by the relative locations of the read and write
pointers and are updated during a retransmit cycle. Data
written to the FIFO after activation of RT1, (RT2) are trans-
mitted also.
The full depth of the FIFO can be repeatedly retransmitted.
Document #: 38-06023 Rev. *C
Page 10 of 39

Share Link: 

datasheetbank.com [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]