AD7701 查看數據表（PDF） - Analog Devices

零件编号

产品描述 (功能)

比赛名单

AD7701

LC2MOS 16-Bit A/D Converter

Analog Devices 

Synchronous External Clock Mode (SEC)

The SEC mode (MODE pin grounded) is designed for direct

interface to the synchronous serial ports of industry-standard

microprocessors such as the COPS series, 68HC11, and 68HC05.

The SEC mode also allows customized interfaces, using I/O

port pins, to microprocessors that do not have a direct fit with

the AD7701’s other modes.

As shown in Figure 20, a falling edge on CS enables the serial

data output with the MSB initially valid. Subsequent data bits

change on the falling edge of an externally supplied SCLK.

After the LSB has been transmitted, DRDY goes high and

AD7701

SDATA goes three-state. If CS is low and the AD7701 is still

transmitting data when a new data-word becomes available, the

old data-word continues to be transmitted and the new data is lost.

If CS is taken high at any time during data transmission, SDATA

and SCLK will go three-state immediately. If CS returns low,

the AD7701 will continue transmission with the same data bit.

If transmission has not been initiated and completed by the time

the next data-word becomes available, and if CS is high, DRDY

will return high for four clock cycles, then fall as the new word

is loaded into the output register.

CLKIN (I)

DRDY (O)

72 CLKIN

CYCLES

CS (I)

HI-Z

SDATA (O)

HI-Z

SCLK (O)

DB15 (MSB) DB14

DB2

DB1

HI-Z

DB0 (LSB)

HI-Z

Figure 19. SSC Mode Showing Data Timing Relative to SCLK

DRDY (O)

CS (I)

SCLK (I)

SDATA (O)

HI-Z

DB15

(MSB)

DB14

DB13

DB1

DB0

(LSB)

HI-Z

Figure 20. Timing Diagram for the SEC Mode

REV. E

–15–

Share Link: