LC866428A 查看數據表（PDF） - SANYO -> Panasonic

零件编号

产品描述 (功能)

比赛名单

LC866428A

8-Bit Single Chip Microcontroller

SANYO -> Panasonic 

LC866432A/28A/24A/20A/16A/12A/08A

(8) Timer

- Timer 0

16-bit timer / counter

2-bit prescaler + 8-bit programmable prescaler

Mode 0 : Two 8-bit timers with programmable prescaler

Mode 1 : 8-bit timer with programmable prescaler + 8-bit counter

Mode 2 : 16-bit timer with programmable prescaler

Mode 3 : 16-bit counter

The resolution of Timer is tCYC (tCYC : cycle time)

- Timer 1

16-bit timer / PWM

Mode 0 : Two 8-bit timers

Mode 1 : 8-bit timer + 8-bit PWM

Mode 2 : 16-bit timer

Mode 3 : Variable-bit PWM (9 - 16 bits)

In Mode 0 and Mode1, the resolution of Timer and PWM is tCYC.

In Mode 2 and Mode 3, the resolution of Timer and PWM selectable : tCYC or 1 / 2 tCYC by program.

- Base timer

Every 500ms overflow system for a clock application (using 32.768kHz crystal oscillation for Base timer clock)

Every 976µs, 3.9ms, 15.6ms, 62.5ms overflow system (using 32.768kHz crystal oscillation for Base timer clock)

The Base timer clock selectable ; 32.768kHz crystal oscillation, System clock, and programmable prescaler

output of Timer 0

(9) Buzzer output

- The Buzzer sound frequency selectable ; 4KHz, 2KHz (using 32.768kHz crystal oscillation for Base timer clock)

(10) Remote-control receiver circuit (Shares with the P73 / INT3 / T0IN terminal)

- Noise Rejection function (the time constant of noize rejection filter : 1 tCYC / 16 tCYC / 64 tCYC )

(tCYC : instruction cycle time)

- Switch Polarity function

(11) Watchdog timer

- The watchdog timer is taken on RC outside

- Watchdog timer operation selectable : interrupt system, system reset

(12) Interrupt system

- 14-source 10-vectored interrupts :

1. External interrupt INT0 (include watchdog timer)

2. External interrupt INT1

3. External interrupt INT2, Timer / counter T0L (Lower 8-bit)

4. External interrupt INT3, base timer

5. Timer / counter T0H (Upper 8-bit)

6. Timer T1L, Timer T1H

7. Serial-interface SIO0

8. Serial-interface SIO1

9. AD converter

10. VFD automatic display controller, Port 0

- Built-in Interrupt Priority control register

microcontroller allows 3 levels of interrupt; low level, high level, and highest level of multiplex interrupt. It

can specify a low level or a high level interrupt priority from INT2 / T0L through port 0 (i.e. the above

interrupt number from three through ten). It can also specify a low level or the highest level interrupt priority

to INT0 and INT1.

(13) Real-time service operation

The Real-Time Service (RTS) functions the 4-byte data-transfer between the Special Function Registers at

acknowledging the interrupt request.

The RTS starts within 1 instruction cycle-time and completes within 5 instructions cycle-time after occurring

the interrupt request.

No.6739-3/22

Share Link: