RT9248 查看數據表（PDF） - Richtek Technology
零件编号
产品描述 (功能)
比赛名单
RT9248 Datasheet PDF : 14 Pages
| |||
Preliminary
RT9248
Functional Pin Description
VID4 (Pin 1), VID3 (Pin 2), VID2 (Pin 3), VID1 (Pin 4),
VID0 (Pin 5) & VID125 (Pin 6)
DAC voltage identification inputs. Tie VID125 to GND for
VRM9 or to VCC for VRD10. These pins are internally
pulled to 3.3V if left open.
SGND (Pin 7)
VCORE differential sense negative input.
FB (Pin 8)
Inverting input of the internal error amplifier.
COMP (Pin 9)
Output of the error amplifier and input of the PWM
comparator.
PGOOD (Pin 10)
Power good open-drain output.
DVD (Pin 11)
Programmable power UVLO detection or converter enable
input.
SS (Pin 12)
Connect this SS pin to GND with a capacitor to set the
soft-start time interval.
RT (Pin 13)
Switching frequency setting. Connect this pin to GND with
a resistor to set the frequency.
Frequency vs. RRT
450
400
350
300
250
200
150
100
50
0
0
10 20 30 40 50 60 70
RRT (k Ω)
DS9248-05 March 2007
VOSS (Pin 14)
VCORE initial value offset. Connect this pin to GND with a
resistor to set the offset value.
IMAX (Pin 15)
Over-Current protection set.
VSEN (Pin 16)
VCORE differential sense positive input.
VDIF (Pin 17)
VCORE differential sense output.
ADJ (Pin 18)
Current sense output for active droop adjust. Connect a
resistor from this pin to GND to set the load droop.
GND (Pin 19)
IC ground.
ISN23 (Pin 20)
RDS(ON) current sense inputs from converter 2nd & 3rd phase
channel sense components' GND node.
ISP1 (Pin 23), ISP2 (Pin 22), ISP3 (Pin 21)
RDS(ON) current sense inputs for individual converter
channels. Tie this pin to the component's sense node.
ISN1 (Pin 24)
RDS(ON) current sense inputs from converter 1st channel
sense component's GND node.
PWM1 (Pin 27), PWM2 (Pin 26), PWM3 (Pin 25)
PWM outputs for each driven channel. Connect these pins
to the PWM input of the MOSFET driver. For systems
which use 2 channels, connect PWM3 high.
VCC (Pin 28)
IC power supply. Connect this pin to a 5V supply.
www.richtek.com
3
Share Link: 