ST16654 查看數據表（PDF） - Exar Corporation

零件编号

产品描述 (功能)

比赛名单

ST16654

QUAD UART WITH 64-BYTE FIFO AND INFRARED (IrDA) ENCODER/DECODER

Exar Corporation 

ST16C654/654D

SYMBOL DESCRIPTION

Symbol

IRTX A-B

IRTX C-D

MIDICLK

-RESET

RESET

R/-W

Rev. 4.10

Pin

Signal

68 100 64 type

Pin Description

ated with the 68 mode only. In the 68 mode, interrupts from

UART channels A-D are WIRE-OR’ed” internally to function

as a single IRQ interrupt. This pin transitions to a logic 0 (if

enabled by the interrupt enable register) whenever a UART

channel(s) requires service. Individual channel interrupt

status can be determined by addressing each channel

through its associated internal register, using -CS and A3-

A4. In the 68 mode an external pull-up resistor must be

connected between this pin and Vcc. The function of this pin

changes to INTA when operating in the 16 mode, see

definition under INTA.

- 6,24 -

- 57,75 -

O Infrared Transmit Data Output (IrDA) - This function is

associated with 100 pin packages only. These pins provide

separate infrared IrDA TX outputs for UART channel’s (A-

D). The serial infrared IRTX data is transmitted via these

pins with added start, stop and parity bits. The IRTX signal

will be a logic 0 during reset, idle (no data), or when the

transmitter is disabled. MCR bit-6 selects the standard

modem or infrared interface.

-

42

-

I MIDI (Musical Instrument Digital Interface) Clock Input -

This function is associated with 100 pin packages only. RXC

and TXC can function as MIDI input/output ports when an

external MIDI Clock is provided at this pin. External Clock

or a crystal is connected to the XTAL1/2 pins for normal

operation (see XTAL 1 & 2).

37 43 27

18 15

-

I Reset. - In the 16 mode a logic 1 on this pin will reset the

internal registers and all the outputs. The UART transmitter

output and the receiver input will be disabled during reset

time. (See ST16C654 External Reset Conditions for initial-

ization details.) When 16/-68 is a logic 0 (68 mode), this pin

functions similarly but, as an inverted reset interface signal,

-RESET.

I Read/Write Strobe (active low) - This function is associated

with the 68 mode only. This pin provides the combined

5-72

Share Link: