MP8799
CMOS
Very Low Power, 1 MSPS, 10-Bit
Analog-to-Digital Converter with 8-Channel Mux
FEATURES
BENEFITS
• 10-Bit Resolution
• Reduced Board Space (Small Package)
• 8-Channel Mux
• Reduced External Parts, No Sample/Hold Needed
• Sampling Rates from <1 kHz to 1 MHz
• Suitable for Battery & Power Critical Applications
• Very Low Power CMOS - 30 mW (typ)
• Designer can Adapt Input Range & Scaling
• Power Down; Lower Consumption – 3 mW (typ)
APPLICATIONS
•
•
Input Range between GND and VDD
No S/H Required for Analog Signals less than 100 kHz
•
µP/DSP Interface and Control Applications
• No S/H Required for CCD Signals less than 1 MHz • High Resolution Imaging – Scanners & Copiers
• Single Power Supply (4 to 6 Volts)
• Wireless Digital Communications
• Latch-Up Free
• Multiplexed Data Acquisition
• High ESD Protection: 4000 Volts Minimum
• 3 V Version: MP87L99
GENERAL DESCRIPTION
The MP8799 is a flexible, easy to use, precision 10-bit
Analog-to-Digital Converter with 8-channel mux that operates
over a wide range of input and sampling conditions. The
MP8799 can operate with pulsed “on demand” conversion
operation or continuous “pipeline” operation for sampling rates
up to 1 MHz. The elimination of the S/H requirements, very low
power, and small package size offer the designer a low cost
solution. No sample and hold is required for charge couple
device applications up to 1 MHz, or multiplexed input
applications when the signal source bandwidth is limited to 100
kHz. The input architecture of the MP8799 allows direct
interface to any analog input range between AGND and AVDD (0
to 2 V, 1 to 4 V, 0 to 5 V, etc.). The user simply sets VREF(+) and
VREF(–) to encompass the desired input range.
Scaled reference resistor tap @ 1/4 R, 1/2 R and 3/4 R allows
for customizing the transfer curve as well as providing a 1/2 span
reference voltage. Digital outputs are CMOS and TTL
compatible.
The MP8799 uses a two-step flash technique. The first
segment converts the 4 MSBs and consists of 15 autobalanced
comparators, latches, an encoder, and buffer storage registers.
The second segment converts the remaining 6 LSBs.
When the power down input is “high”, the data outputs DB9 to
DB0 hold the current values and VREF(–) is disconnected from
VREF1(–). The power consumption during the power down mode
is approximately 3mW.
ORDERING INFORMATION
Package
Type
PQFP
Temperature
Range
–40 to +85°C
Part No.
MP8799AE
DNL
(LSB)
1
INL
(LSB)
2
Rev. 3.00
1