HSP50016-EV 查看數據表（PDF） - Intersil

零件编号

产品描述 (功能)

比赛名单

HSP50016-EV

DDC Evaluation Platform

Intersil 

HSP50016-EV

When a successful compare has been done, the software

message returned is:

- Comparing files TEST_OUT.DAT and CMPRFILE.DAT

- FC: No differences encountered

The most common causes of test failures are incorrect board

jumper settings, incorrect comm port selection, or a

corrupted eval.cfg file. It is helpful to delete the file

TEST_OUT.DAT, prior to the test, to ensure that DDC.CHK

runs properly and that a new TEST_OUT.DAT file was

created.

NOTE: if the operating system precedes DOS 6.0, the

user should answer NO to the COMP command prompt

to compare additional files. DOS Version 6.0 and above

use a different file compare command, so this step is

not necessary. DDCCHK checks the version

automatically and executes the proper compare routine.

The DDCCHK system test assumes that the LPT1 printer port

is being used for communication with the HSP50016-EV. If

another printer port is used, the Command Line Interface,

DDCCMD, must be used to configure the software for using

the correct port (see DDCCMD’s PPC and PP# command).

P2

IQSTB SELECT

QOUT SELECT

1

JP20

1

JP19

J1

CABLE

J3

J2

JP1

JP2

JP3

JP5

JP6

JP7

JP8

JP9

JP10

JP11

JP12

JP13

JP14

JP15

JP16

JP17

JP18

EXT_CLK

OSC_CLK

PC_CLK

DATA_OE

ADDR0

ADDR1

ADDR2

ADDR3

ADDR4

ADDR5

ADDR6

ADDR7

DDC_CLK_INV

OUT_CLK_INV

CLK_OUT

CLK_IN

TAP_SEL

P1

FIGURE 1. LAYOUT OF HSP50016-EV SHOWING DEFAULT JUMPER CONFIGURATION

3

CLOCK

SELECT

OUTPUT

ENABLE

BOARD

ADDRESS

CLOCK

SELECT

Share Link: