One Cylinder Small Engine Control IC
The 33813 is an engine control analog power IC intended for one cylinder motorcycle and other small engine control applications. The IC consists of five integrated low side drivers, two pre-drivers, a Variable Reluctance Sensor (VRS) input circuit, a voltage pre-regulator using an external pass transistor, and two 5.0 volt internal regulators, one for the microcontroller unit (MCU) VCC supply and the other for use as a protected sensor supply.
FEATUREs:
• Operates over a supply voltage range of 4.5 V VPWR 36 V
• Logic stability guaranteed down to 2.5 V
• One fuel injector driver - typical of 1.3 A
• One ignition IGBT or general purpose gate pre-driver
• One O2 sensor (HEGO) heater general purpose gate pre-driver
• Relay 1 driver, typically 2.0 A, can be used for fuel pump control
• Relay 2 driver, typically 1.0 A, can be used as power relay control
• Lamp driver, typically 1.0 A can also be used to drive an LED
• VPROT protected sensor supply tracks VCC +5.0 V regulator
• MCU reset generator -system integrity monitor (watchdog)
• VPP pre-regulator provides power for VCC and VPROT regulators
• Independent fault protection with all faults reported via the SPI
• ISO 9141 K-line interface for communicating diagnostic messages
• Start-up / shut-down control and power sequence logic
• Interfaces directly to MCU using a 5.0 V SPI and logic I/O
• Differential / single-ended VRS conditioning circuit with auto/manual selected thresholds and filter times with digital and tachometer outputs
APPLICATIONs
Small Engine Control for:
• Lawn Mowers
• Motor Scooters
• Small Motorcycles
• Lawn Trimmers
• Snow Blowers
• Chain Saws
• Gasoline-driven Electrical Generators
• Outboard Motors