General Description
The APW7004 provides a complete control and multiple protection for a DC-DC converter optimized for high performance microprocessor applications. It is designed to drive two N-Channel MOSFETs in a synchronous-rectified buck topology. The APW7004 integrates output voltage control, output voltage programming, monitoring and protection functions into a single chip IC.

FEATUREs
• Simple Single-Loop Control Design-Voltage Mode PWM Control
• Fast Transient Response
    • High-Bandwidth Error Amplifier
• 5-Bit Digital-to-Analog Output Voltage Selection
    • Wide Range from1.3VDC to 3.5VDC
    • 0.1V Binary Steps from 2.1VDC to 3.5VDC
      .05V Binary Steps from 1.3VDC to 2.05 VDC
• VID0-4 Input Pins with Pull High Resistors Built in
• Power-Good Output Voltage Monitor, PGOOD Pin with an Open Collector Configuration
• Over-Voltage and Over-Current Fault Monitors
    • Uses MOSFET’s RDS(ON) as Current Sensing, No Extra Element Required
• Programmable Switching Frequency Setting
    • 200kHz Free-Running Oscillator

APPLICATIONs
• Power Supply for Pentium TM, Pentium ProTM, Pentium TM II,PowerPC TM, K6 TM , 6´86TM and AlphaTM Microprocessors
• High-Power 5V to 3.xV (or below) DC-DC Regulators
• Low-Voltage Distributed Power Supplies