GENERAL DESCRIPTION
The EN25S80 is an 8 Megabit (1024K-byte) Serial Flash memory, with advanced write protection mechanisms. The EN25S80 supports the standard Serial Peripheral Interface (SPI), and a high performance Dual output as well as Dual I/O using SPI pins: Serial Clock, Chip Select, Serial DQ0(DI) and DQ1(DO). SPI clock frequencies of up to 50MHz are supported allowing equivalent clock rates of 100MHz for Dual Output when using the Dual Output Fast Read instructions. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction.

FEATURES
• Single power supply operation
    - Full voltage range: 1.65-1.95 volt
• Serial Interface Architecture
    - SPI Compatible: Mode 0 and Mode 3
• 8 M-bit Serial Flash
    - 8 M-bit/1024 K-byte/4096 pages
    - 256 bytes per programmable page
• Standard or Dual SPI
    - Standard SPI: CLK, CS#, DI, DO, WP#, HOLD#
    - Dual SPI: CLK, CS#, DQ0, DQ1, WP#, HOLD#
• High performance
    - 75MHz clock rate for one data bit
    - 50MHz clock rate for two data bits
• Low power consumption
    - 7 mA typical active current
    - 1 μA typical power down current
• Uniform Sector Architecture:
    - 256 sectors of 4-Kbyte
    - 16 blocks of 64-Kbyte
    - Any sector or block can be erased individually
• Software and Hardware Write Protection:
    - Write Protect all or portion of memory via software
    - Enable/Disable protection with WP# pin
• High performance program/erase speed
    - Page program time: 1.3ms typical
    - Sector erase time: 90ms typical
    - Block erase time 500ms typical
    - Chip erase time: 5 Seconds typical
• Lockable 256 byte OTP security sector
• Minimum 100K endurance cycle
• Package Options
    - 8 pins SOP 150mil body width
    - 8 pins SOP 200mil body width
    - 8 contact VDFN
    - All Pb-free packages are RoHS compliant
• Industrial temperature Range