Round-type contact mount LEDs (for automatic insertion)

● SEL6000 series LEDs packaged on tapes can withstand shocks caused by insertion machines; Thus, they can be contact-mounted automatically on circuit boards.

■ Using contact mount LEDs packaged on tapes
1. Printed circuit board
   ● One-side printed circuit board is recommended.
   ● If there are several SMD parts on the same printed circuit board, insert the LEDs after the adhesive for other SMD parts hardened.
2. Insertion conditions
   ● Use low insertion pusher pressure, as much as possible.
   ● Cut and clinch: Panasert T pattern is recommended.
      For N pattern, make the clinching angle of the LED’s anode as small as possible.
3. Soldering conditions
   ● Preheating must be less than 90°C (temperature on printed circuit board’s bottom surface) for no more than two minutes
   ● Solder dipping must be made at a temperature of 250°C for no more than 3 seconds.