MU9C8328A-RDC 查看數據表（PDF） - Music Semiconductors

零件编号

产品描述 (功能)

比赛名单

MU9C8328A-RDC

Ethernet Interface

Music Semiconductors 

MU9C8328A Ethernet Interface

GENERAL DESCRIPTION Continued

selected, notifies the controller whether to copy or purge

the frame. The SA is then sent to the LANCAM for

comparison, and if no match is found, can be learned to

the Next Free address in the LANCAM. Scheduling is

done within the MU9C8328A so that each filtering action

completes in the time of a minimum length frame. The

filtering and learning routines are preprogrammed in the

MU9C8328A, with decision options set in the Control

register. A Status register is provided so the host

processor can determine the results of activities. The

specific Op-Code for the LANCAM learning instruction

is by default a MOV NF, CR, V, but it can be overridden by

writing a value to the Op-Code register. Aging and purging

activity is directly controlled by the host processor. The

READY signal notifies the host processor that processor

operations are complete. The /INT signal notifies the

processor that a network frame has been processed and

the result stored in the Status register. The processor can

turn off the network filtering activity to have total control

of the LANCAM; during this time the controller can be

notified to accept or reject all frames.

PIN DESCRIPTIONS

All signals are implemented in CMOS technology with TTL levels. Signal names that start with a slash (“/”) are active

LOW. Inputs should never be left floating. Refer to the Electrical Characteristics section for more information.

NETWORK INTERFACE

SERCLK (Serial Clock, Input, TTL)

SERCLK is the nominally 10 MHz clock from the Ethernet

controller chip to the MU9C8328A. Frame parsing begins

only after the internal clock detector determines that

SERCLK is valid. Internally pulled down with nominal

50K resistor.

SERDAT (Serial Data, Input, TTL)

SERDAT is the NRZ data from the 10 MHz Ethernet

controller chip. The MU9C8328A uses SERCLK to strobe

SERDAT looking for a Start Frame delimiter (SFD), at

which point it begins filtering and learning activity on

the Destination Address (DA) and Source Address (SA).

/REJECT (Reject, Output, TTL)

The MU9C8328A takes /REJECT LOW to notify the

Ethernet controller chip to reject a frame under conditions

set in the Filter Control register.

/NETRDY (Network Ready, Input, TTL)

If /NETRDY is LOW, the MU9C8328A begins parsing frame

data received on the SERDAT input if SERCLK is valid.

The Ethernet controller chip, or the user, takes

/NETRDY HIGH to indicate that SERCLK or SERDAT

is invalid or is transmitting. The MU9C8328A frame parser

and internal state machines are returned to an idle state

after safely completing any LANCAM activity, while

ignoring any compare results. Internally pulled down with

nominal 50K resistor.

PROCESSOR INTERFACE

SYSCLK (System Clock, Input, TTL)

SYSCLK is a 20 MHz to 33 MHz continuous clock provided

by the host system and is the master clock within the

MU9C8328A. It is used to determine the presence of a valid

clock on the SERCLK input, operate the three internal state

machines, and provide the proper timing of the signals on

the LANCAM port. If SYSCLK is below 30 MHz, a

LANCAM speed grade of 120 ns is acceptable. Above 30

MHz, a LANCAM speed grade of 90 ns or better is required.

/CS (Chip Select, Input, TTL)

/CS is taken LOW by the host processor to gain access to

the registers of the MU9C8328A or to directly access the

LANCAM through the MU9C8328A internal LANCAM

registers. The state of /CS becomes effective on the rising

edge of SYSCLK. When /CS goes HIGH, the MU9C8328A

continues filtering and learning based on conditions set in

the Filter Control register and the frame activity on the

network interface.

/AS (Address Strobe, Input, TTL)

The falling edge of /AS latches the A(2–0) bus, and when

both /AS and /CS are LOW, the processor state machine

is enabled by first rising edge of the SYSCLK to begin

writes into or reads out of the MU9C8328A.

Rev. 0.8 Draft

2

Share Link: