UPC1935 查看數據表（PDF） - NEC => Renesas Technology

零件编号

产品描述 (功能)

比赛名单

UPC1935

DC-DC CONVERTER CONTROL IC

NEC => Renesas Technology 

µ PC1935

3.5 ON/OFF Control

3.5.1 Channel 1 (for step-up)

The ON/OFF signal control method of the output oscillation of channel 1 is to input the ON/OFF signal from ON1 as

shown in Figure 3-3. For channel 1, soft start or timer latch (SCP) is internally selected. Soft start is executed when the

first start signal is input. When the end of soft start is detected, the soft start select switch is turned OFF and the timer

latch circuit operates.

Figure 3-3 ON/OFF Control (channel 1 for step-up)

VO1

(Converter

output

R11

voltage)

R12

D11

ON1

Q11

CDLY

FB1

II1

–

+ Error amplifier

0.3 V

VREF

R1

Dead time

setting: 85 %

(internally fixed)

SCP comparator

(common to each channel)

+

Q1

–

0.63 V

To output stage

+

+

–

PWM comparator

Oscillation section

SW (common to each channel)

DLY

(1) When ON1 is high: OFF status

Q11: ON → DLY pin: Low level → Output duty of PWM comparator: 0 %

D11: ON → II1 pin: High level → FB1 output: Low level

(2) When ON1 is low: ON status (start up)

Q11: OFF → CDLY is charged in the sequence of [VREF → R1 → SW → DLY pin → CDLY] → Soft start

D11: OFF → II1 pin: Low level → FB1 output: High level

(3) When ON1 goes high again after start up (SW: OFF): OFF status

Q11: ON → DLY pin: Low level (Nothing happens because SW is OFF.)

D11: ON → II1 pin: High level → FB1 output: Low level → PWM comparator output duty: 0 %

→ Converter output voltage (VO1) drops.

Caution Even if start up is executed by making ON1 low again after (3), soft start is not executed because the

soft start select switch (SW) remains OFF. To execute soft start of channel 1 again, drop VCC to 0 V

once.

Data Sheet G13418EJ3V0DS00

17

Share Link: